Recording on MDs
This chapter explains the various ways to record to an MD, as well as how to mark track numbers and perform
Notes on Recording
About indications which appear while
recording
When “Protected” and “C11” alternate in the display
The
When “Din Unlock” and “C71” alternate in the display
•The digital component selected with the INPUT selector is not connected correctly. Check the connection.
•The selected digital component is not turned on. Turn on the component.
When “Cannot Copy” appears in the display
The MD deck uses the Serial Copy Management System. MDs recorded through the digital input connector can’t be copied to other MDs or DAT tapes through the digital output connector. For details, see “Guide to the Serial Copy Management System” on page 15.
When “TRACK” flashes in the display
The MD deck is recording over existing track(s) (see “Recording on an MD” on page 15). The indication stops flashing when the deck reaches the end of the recorded portion.
About indications which appear after
recording
When “TOC” lights up in the display
Recording has finished but the TOC (Table of Contents) on the MD has not been updated to reflect the recording results. The recording will be lost if you disconnect the mains lead while the indication is on. The TOC will be updated only when you eject the MD or turn off the MD deck.
When “TOC Writing” flashes in the display
The deck is updating the TOC. Do not disconnect the mains lead or move the deck while the indication flashes.