Playing MDs
Creating Your Own Programme (Programme Play)
To enter a track number over 10 Z
Use >10. For details, see page 25.
To check the total playing time of the programme
Press LEVEL/DISPLAY/CHAR (or DISPLAY).
4Repeat step 3 to enter other tracks.
The entered track is added to the location where the “0” flashes.
Each time you enter a track, the total programme time appears in the display.
5Press YES.
“Complete!!” appears and the programme is completed.
6Press PLAY MODE repeatedly until “PROGRAM” lights up in the display.
7Press H.
Programme Play starts.
To stop Programme Play
Press x.
To resume normal play
Press PLAY MODE repeatedly until “PROGRAM” turns off.
zThe programme remains even after Programme Play ends or is stopped
Press H to play the programme again.
Notes
•If you turn off the deck or disconnect the mains lead, the programme will be lost.
•The display shows “- - - m - - s” when the total playing time of the programme exceeds 199 minutes.
•“ProgramFull!” appears when you try to programme 26th track.
Checking the contents of the programme
While the deck is stopped and “PROGRAM” lights up, press LEVEL/DISPLAY/CHAR (or DISPLAY) repeatedly.
The first several tracks in the programme appear in the display. To see the rest of the programme, turn AMS (or press ./> repeatedly).
Changing the contents of the programme
While the deck is stopped and “PROGRAM” lights up, do steps 1 and 2 of “Programming the tracks” on page 27, followed by one of the procedures below:
To | Do the following: |
|
|
Erase a track | Press m/M repeatedly until the |
| number of the unwanted track flashes, |
| then press CLEAR. |
|
|
Erase all tracks | Press CLEAR repeatedly until all the track |
| numbers disappear. |
|
|
Add a track at the | Press m repeatedly until “0” flashes |
beginning of the | before the first track number, then do steps |
programme | 3 to 5 of “Programming the tracks” on |
| pages 27 and 28. |
|
|
Add a track in the | Press m/M repeatedly until the track |
middle of the | number which will precede the new track |
programme | flashes. Press AMS to display flashing |
| “0, ” then do steps 3 to 5 of “Programming |
| the tracks” on pages 27 and 28. |
|
|
Add a track to the | Press M repeatedly until “0” flashes |
end of the | after the last track number, then do steps |
programme | 3 to 5 of “Programming the tracks” on |
| pages 27 and 28. |
|
|
Replace a track | Press m/M repeatedly until the |
| number of the track to be changed flashes, |
| then do steps 3 to 5 of “Programming the |
| tracks” on pages 27 and 28. |
|
|