6Repeat steps 1 to 4 for other devices you wish to set up the remote control for.
Write your codes down here for easy reference later.
Device | Code |
TV |
|
AUDIO |
|
DVR |
|
SAT |
|
|
|
|
|
Notes
•After a valid code entry, the red light indicator turns off. For an invalid code, the red light indicator flashes first, then turns off. In this case you have to enter Setup mode again and enter a new code.
•If some buttons do not operate your equipment, try one of the other codes for your brand.
Note
You can store any kind of code under any mode (except TV). For example: you can store a DVR code under the CBL button, or a DVD code under the DVR button, etc. However, you can only store TV codes under the TV button.
If you wish to store a DVR code under e.g. the CBL button:
•First follow the procedure for ‘Direct code entry’ (chapter 3.2.2) and press CBL in step 3.
•Enter any DVR code in step 4.
•Then follow the steps for ‘Code search by brand’ (chapter 3.2.1).
•If the device does not have a CH + button, use the PLAY (2) - DVR only - or POWER (y) button instead.
•Code Search starts from the currently stored 4 digit number under that mode.
3.3 Programming combo devices
For Combo Devices, in many cases a single code operates both parts of the device (e.g.TV and DVD). In other cases you need to set up two codes. For example, if you have a TV / DVD combo, you need to set up one code under the TV button to control the TV part and a separate code (under any other Mode button) to control the DVD part.
3.4Copy Volume / Mute buttons from another device
When setting the remote control up for your devices, the remote control copies the Volume / Mute settings as follows:
•If a device has its own Volume / Mute buttons in the remote control database, then these buttons will be used.
•If a device has no Volume / Mute buttons in the remote control database, the Volume / Mute buttons of the TV will be used automatically.
8EN
129238_SRU5108_Short.indd 8 |