3 Getting started
3.1 Battery installation
•Insert 2 AA type
Alkaline batteries, noting the + and – configuration in the battery compartment.
Getting started English
3.2 Code setup
The SETUP button is used to setup the remote control.
Refer to ‘Code Tables’ (on separate sheet) to find the code(s) for your device(s).
3.2.1 Code search by brand
Lets you search for a code for a specific brand within the code library for a particular manufacturer.
1Turn on the device (TV, DVR, etc.) you wish to operate.
2Press and hold the SETUP button until the red light indicator remains lit, then release the SETUP button.
3Press and quickly release the desired mode button (TV, DVR , etc.).
•The red light indicator flashes off once.
4Press and release the digit button
•The red light indicator flashes off once.
5Press the CH + button (or POWER (y) or PLAY (2) - DVR only) repeatedly until the device changes channel.
•The red light indicator flashes off with each button press.
6Press and release the MUTE button to install (store) the code.
•Code search by brand is now complete.
Notes
•When all codes under a brand have been searched for, the red light indicator flashes rapidly for 3 seconds.
•If you accidentally overshoot the required code in step 5, press the CH – button to backtrack through the library until the device changes channel. Pressing the CH + button changes the search direction to forward again.
3.2.2 Direct code entry
1Turn on the device (TV, DVR, etc.) you wish to operate.
2Press and hold the SETUP button until the red light indicator remains lit, then release the SETUP button.
3Press and release the desired mode button (TV, DVR, etc.).
•The red light indicator flashes, then remains lit.
4Enter the 4 digit code from the code tables (on separate sheet).
5With the device turned on, press several buttons to test if the device responds.
•If the device responds properly, you have successfully found a valid code for your device.
EN 7
129238_SRU5108_Short.indd 7 |