•Do not move or change the distance between the two remote controls until you have learned all the required buttons for the selected mode.
•When learning, do not release the button being learned until the red light indicator has flashed off for half a second.
•Avoid learning your original remote control Volume / Mute buttons unless you are sure these operate the same device e.g. some original DVD remote controls include TV Volume / Mute button control and can have two different types of code.
•Avoid learning your original remote control DVR control buttons unless you are sure these operate the same device e.g. some original TV remote controls include DVR button control and can have two different types of code.
•If you have continual problems learning from your original remote control, try clearing all learned commands as described in chapter 5.2.1 ‘Clearing all learned commands under a mode’.
6 Troubleshooting
Note
This remote control operates the common features of most but not all models and brands of IR (Infrared) controlled Audio / Video equipment.This remote control may provide functions that are not available on your equipment.
The remote control does not operate your product. Try the following hints to remedy the problem:
•Make sure you selected the correct device mode.
•Set up the remote control with a new code.
•Install new batteries.
•Check if you selected the correct device mode.
The remote control does not operate some features of your product
•Use the L1 and L2 buttons to learn the remote control commands that are not available.
The red light indicator flashes after you program a product code
•The remote control did not accept the code.
•Try to program the code again or try a different code.
When you have additional questions about setup, usage, advanced features, spare parts, warranty, etc. of the SRT5108/27, see www.philips.com/support.
For further help with setup, please call:
12EN
129238_SRU5108_Short.indd 12 |