Philips Digital Video Recorders Motion Detection, Submenu AlarmsInputs, Dwell Time

7.4.1 Submenu <Alarms><<Inputs>>

FIELD			VALUES		DEFAULT VALUE
Auxiliary Alarm Input Polarity -			•	Normally Open	Normally Open
Cameras 1– 4 individually			•	Normally Closed
Auxiliary Alarm Recording			•	Enabled	Disabled
Follows Contact			•	Disabled
Pre-alarm Time			[1 to 60 seconds]		30 seconds
Post-alarm Time:
	Video Motion		[1 to 60 minutes]		1 minute
	Video Dark
		Auxiliary
	1-Touch

NOTE: Use 1-Touch Alarm (front panel) to trigger alarm recording for the duration of the programmed POST ALARM time. Continue alarm recording by pressing 1-Touch Alarm again.

7.4.2Submenu <Alarms><<Outputs>>

FIELD	VALUES		DEFAULT VALUE
Warning Beep	•	Enabled	Enabled
	•	Disabled
Relay Output Polarity -	•	Normally Open	Normally Open
Cameras 1– 4 individually	•	Normally Closed
Relay Activation:	[3 to 60 seconds,		5 seconds
Dwell Time -	1 second increments]
Cameras 1– 4 individually
Follows Mode for Aux Alarm -	•	Enabled	Disabled
	•	Disabled

7.5Motion Detection

Motion detection causes the system to alarm based on motion through a zone. Sensitivity, speed, and direction settings can be set via these menus.

19