Philips Digital Video Recorders Data Storage, See Archiving, Section, System

7.6Data Storage

7.6.1Submenu <Data Storage><<Hard Drive>>

FIELD	VALUES		DEFAULT VALUE
Disk Full Behavior	•	Overwrite	Overwrite
	•	Stop Recording	• Stop Recording is the
			default (non-adjustable) if
			a disk array is recognized
Disk 1 Status	•	Good	Calculated
	•	Bad
Disk 2 Status	•	Good	Calculated
	•	Bad
	•	Not Installed
Total Capacity	Hard disk capacity, in GB		Calculated

7.6.2Submenu <Data Storage><<Archive>>

See Archiving, Section 10.

7.7System

7.7.1Submenu <System><<Password>>

FIELD	VALUES & DEFINITION		DEFAULT VALUE
Password Protection	•	Enabled (requires password	Disabled
		for menu access)
	•	Disabled (no password
		required for menu access)

Available Actions:

• Set Password. Press front panel buttons 1 through 4 to set the password (four to ten characters).

NOTE: This password is the same password used by the Hi-Q Management Utility.

7.7.2Submenu <System><<Network>>

The Network menu allows access to settings that control the behavior of the recorder with respect to a network.

•Enter the IP, Subnet Mask, and Default Router addresses.

•Enter a Hi-Q recorder name to be used on the network.

FIELD	VALUES	DEFAULT VALUE
IP Address	[0 –255 in each block]	10.10.0.0
Subnet Mask	[0 –255 in each block]	255.255.255.0
Default Router	[0 –255 in each block]	10.10.0.1
Name	[12 Characters]*	Hi-Qxxxx**

* See Appendix D for Hi-Q on-screen character set.

** XXXX is the last 4 digits of the Hi-Q recorder serial number.

21