dbx Pro 260 user manual DriveRack, Stereo Bi-amp w/ Dual Delay

Page 71

DriveRack™	Application Guide	Section 7

	7.4 - Stereo Bi-amp w/ Dual Delay

Hardware

1.Connect the outputs from the mixer to the inputs of the DriveRack™.

2.Connect the outputs of the DriveRack™ and run to the selected speaker amplifier.

3.Making sure that all outputs are muted, apply power to the mixer and amplifiers.

4.Make connections between the Zone Controllers (see Section 6.2) and the 260.

Software

1.Select a program (Factory: 1x4 w/ 2 Zones) as a template.

2.Load the program by pressing the PROG/CONFIG button.

3.Adjust the individual parameters for the system by pressing the Processing Module buttons.

4.Using the Utility Menu, select the ID for each ZC-1 and ZC-2 Zone Controller and program its output level boost and cut parameters.

Left		Right
2	3	4	5	dbx ZC-2
				dbx ZC-2
MA-5002VZ
				JBL Control 25
				Zone A
JBL AE Series
AM6315/95

JBL AE Series	dbx ZC-1
AC2212/95

Zone B

JBL AE Series

ASB6128

®

DriveRack™ User Manual	63

Image 71

Contents 260 Important Safety Instructions Electromagnetic Compatibility DriveRack Table of ContentsIntro Defining the 260 DriveRack System DriveRack featuresIntroductionDriveRack DriveRackIntroduction Service Contact InfoIntroductionDriveRack Warranty Section Front Panel Getting StartedRear Panel Connections Input Meters LCD DisplayData Wheel Function ButtonsOutput Meters Quick StartDriveRack Stereo System SetupSub Speaker AFS Wizard Auto EQ WizardAFS Select total number of AFS filters Slowly Increase Mixer gain to Desired level DriveRack Section Effect Button Array Overview Editing FunctionsBasic Navigation Modes Navigating the Xover Section Navigating the EQ -GEQ and PEQNavigating the Dynamics Section Navigating the Other SectionNavigating the Utility/Meters Section Navigating the Delay SectionNavigating the I/O Section Navigating the Wizard SectionFunctions Selecting Programs Configuring the DriveRackProgram Definition Navigating Factory ProgramsNavigation Modes Editing Factory ProgramsSaving Factory Programs Changes Store Program ReplacingLink/Unlink Creating a User ConfigurationSignal Path SelectSelect Route Select Link/UnlinkMono DLY 1.3 10 ms Unused Select Link/Unlink Route Name Output Ch2 Mono DLY 20 MS 810 ms Unused Select Link/UnlinkName Rock Venue Saving Configuration ChangesDetailed Pre-Crossover EQ Detailed ParametersFeedback Eliminator Subharmonic Synthesizer Gate Automatic Gain Control AGC Post-CROSSOVER PEQ Notch FiltersCrossover Compressor/Limiter Auto On/Off Threshold T -40 to +20dBuRatio R 1.0 to Inf1 Gain G -20 to +20 dBPeakstop+ On/Off Attack .01 to 200 m Sec per band or globalHold 0 to 500 m Sec per band or global Release 360 to 5 dB / Sec per band or globalInput Routing Alignment DelayShift On/Off Phase 0 toOutput Noise Level -10 to 10 Mixer and RouterMeters 1 LCD Contrast / Auto EQ Plot Power Up Modes PUP Program Stored PUP Mute CurrentUtility LCD Contrast Auto EQ Plot Utilities/Meters3 ZC Setup ZC Setup Panel None4 -6 Security Panel 1 ZC-4 Switch 1 2 3 No ChangePanel ZC-2 Boost 0dB Cut Output Panel 1 ZC-3 Select a No ChangeSet 260 Device Level High Set Security Level Pre EQ LowPassword Enter Password Password Edit High Password Edit Med Password7-8 Program List/Program Change Prog Change Mode Program List Prog LockProgram List List Size List Index 8 Output Jumper Switches Output Jumpers SettingMeters Insa Comp o+LIM 0+ Zone Controllers PanelOutput Trims Net Remote Control PC GUI Installation Remote ControlSection GUI Recommended Cable Specifications ZC-Zone Controllers DriveRack Diagram a Diagram B Zone Controller WiringDriveRack DriveWare Functions Page Guide Software Application GuideMono Four-Way w/ Two Aux Zones HardwareStereo Tri-amp DriveRackStereo with Four Aux Zones DriveRack Stereo Bi-amp w/ Dual DelayDriveRack DriveRackAppendix Power Up Quick Key Options Factory ResetAppendix a SpecificationsLook out for Modes Auto EQ Optimization TipsCrossover Diagrams Program List/ Speaker Tunings/ Power Amp Tunings Block Diagram Input and Output Diagrams Gain Level Jumpers System Setup and Gain StructureDriveRack Harman International Company