Philips 58PFL4909 Preferences, Use Philips EasyLink, Setting your location to home, TV placement

Preferences

You can set the unit to reduce the power consumption or adjust the backlight brightness in Location setting.

In TV placement setting, you can set the unit placement in order to obtain the best sound effect. EasyLink allows you to operate your connected EasyLink device.

Setting your location to home

Choosing Home gives you full flexibility to change predefined settings for picture and sound.

1Use H I to Select Preferences, then press OK.

2 Use H I to Select Location, then press OK.

LanguageLocationRetail

ChannelsEasyLinkHome

Preferences TV placement

Network

Restore default settings

3Use H I to Select Home, then press OK.

	The Unit will be set up with predefined settings for
Retail	retail displays. In this setting, the Power Consumption
	may possibly exceed the limit requirement of the
	ENERGY STARN qualification.
	This setting is ENERGY STARN qualified.
Home	The Unit is set to maximize the energy efficiency for
	Home setting and it can be adjusted through a choice
	of Picture and Sound quality selections according to
	your preference.

Note(s)

●You must set Home in the Menu. Otherwise, personalized Picture and Sound Settings will Not Be Memorized after the Unit goes into Standby Mode.

●If you select Home, E-sticker will not be displayed.

TV placement

To apply the best settings for your TV, select wall mount or stand mount.

1Use H I to Select Preferences, then press OK.

2 Use H I to select TV placement, then press OK.

3Use H I to select Wall mounted or On a TV stand, then press OK.

E-sticker

When you set Location to Retail, E-sticker (Electronic Sticker) is displayed. E-sticker can be Turned Off using procedure below.

1Use H I to Select Preferences, then press OK.

2 Use H I to select E-sticker, then press OK. 3 Use H I to select Off, then press OK.

35 .English

Use Philips EasyLink

Your TV supports Philips EasyLink, which enables one-touch play and one- touch Standby between EasyLink-compliant devices. Compliant devices must be connected via an HDMI connector.

One-touch play

When you connect your TV to devices that support one-touch play, you can control your TV and the devices with one remote control. For example, when you press K (play) on your DVD remote control, your TV automatically switches to the correct channel to show the DVD content.

One-touch Standby

When you connect your TV to devices that support Standby, you can use your TV remote control to put your TV and all connected HDMI devices in Standby mode. You can perform one-touch Standby using the remote control from any of the connected HDMI devices.

System audio control

When you connect your TV to HDMI CEC compliant devices, your TV can switch automatically to play audio from the connected device. To use one-touch audio, you must map the audio input from the connected device to your TV. You can use the remote control from the connected device to adjust the volume.

Remote control (RC) key forwarding

RC key forwarding allows you to control EasyLink-compliant devices using your TV remote control.

HDMI-ARC (Audio Return Channel) (HDMI 3 only)

HDMI-ARC allows you to use Philips EasyLink to output TV audio directly to a connected Audio device, without the need for an additional Digital Audio cable. Be sure that the device is HDMI CEC and ARC compliant, and that the TV is connected to the device using an HDMI cable attached to both HDMI-ARC connectors.

Note(s)

●Philips does not guarantee 100% interoperability with all HDMI CEC devices.

●The EasyLink-compliant device must be Switched On and selected as the source.

Continued on next page.