Philips 58PFL4609, 58PFL4909 user manual Left and right side, Bottom, Sanus PLA50B, M6 x 0.787 20mm

Important Safety Instructions 4 .English

1.Read these instructions.

2.Keep these instructions.

3.Heed all warnings.

4.Follow all instructions.

5.Do not use this apparatus near water.

6.Clean only with dry cloth.

7.Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.

13.Unplug this apparatus during lightning storms or when unused for long periods of time.

14.Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.

8.Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.

9.Do not defeat the safety purpose of the polarized or grounding type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong.The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.

10.Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.

11.Only use attachments / accessories specified by the manufacturer.

12.Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or

sold with the apparatus.hen a cart is used, use caution when moving the cart / apparatus combination to avoid injury from tip-over.

Note to the CATV system installer:

This reminder is provided to call the CATV system installer’s

attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.

Example of Antenna Grounding as per NEC - National Electric Code

GROUND CLAMP	ANTENNA LEAD IN WIRE
	ANTENNA DISCHARGE UNIT
	(NEC SECTION 810-20)
	GROUNDING CONDUCTORS
	(NEC SECTION 810-21)
	GROUND CLAMPS
ELECTRIC SERVICE EQUIPMENT	POWER SERVICE GROUNDING ELECTRODE
	SYSTEM (NEC ART 250, PART H)

Wall Mount Bracket Kit

Brand Model # Screw dimension

58PFL4909 / 58PFL4609

SANUS

PLA50B

M6 x 0.787” (20mm)

When installing the unit on the wall, allow this much space.

Top:	11.8 inches (30cm)
Left and right side:	5.9 inches (15cm)
Bottom:	3.9 inches (10cm)