Manual network settings
2Use H I to select Manual network settings, then press OK.
Network settings assistant | Network selection | Wireless |
Manual network settings | Wireless network setting | Auto |
Connection test | IP configuration | IP setting mode |
Setting status | Proxy configuration | Proxy setting |
Home network |
|
|
Reset network settings |
|
|
|
|
|
Network selection
3Use H I to select Network selection, then press OK.
4 Use H I to select the desired setting, then press OK.
Wired | If you connect to an Ethernet cable, select Wired | |
to connect to the Internet. | ||
| ||
Wireless | If you have a router with WPS function, select | |
Wireless to connect to the Internet. | ||
|
Wireless network setting
This menu is displayed only when you set Wireless in Network selection. In order to use a wireless network, you must set up a connection to the AP (e.g. wireless router).
3Use H I to select Wireless network setting, then press OK.
Auto
Search for wireless networks automatically and select the SSID from the list.
4Use H I to select Auto, then press OK.
5The list of wireless networks will be displayed. Use H I to select the appropriate the SSID, then press OK.
Auto | Router 1 | Enter Key |
Manually enter your SSID | Router 2 | Select |
| Router 3 | Enter Key |
| Router 4 | Select |
|
|
|
●If you select the SSID with 
, WEP*2 / WPA / WPA2 Key entry
screen will appear. Enter the WEP*2 / WPA / WPA2 key of the selected wireless network using H I J K, then press OK.
●If you select the SSID has a WPS, the WPS setting screen will appear. Use H I J K to select a setting, then press OK.
38 .English
| Select this setting if your router has a | |
| Protected Setup (WPS) button. Start scanning | |
Easy Connect | for wireless networks on the TV after pressing | |
the WPS button on your router. If connection | ||
| ||
| test fails, try Easy Connect again.*1 If it fails then | |
| refer to the router’s manual for more details. | |
| Select this setting if your router has a WPS but | |
WPS code | does not have a WPS button. Enter the | |
WPS PIN code shown on your TV in the router | ||
| ||
| settings menu via PC before Connect is selected. | |
| If your wireless network with authentication | |
| setting (WEP*2, WPA or WPA2), WEP*2 / | |
Manual | WPA / WPA2 Key entry screen will appear. Enter | |
the WEP*2 / WPA / WPA2 key of the selected | ||
| ||
| wireless network using H I J K, then press | |
| OK. |
*1 WPS (Easy Connect) cannot be used when the security protocol is set to WEP. Change the Access Point’s security mode from WEP to WPA or WPA2 (recommended).
*2 WEP is not recommended to be used due to its Major security flaws. Change the Security protocol on the wireless router to WPA or WPA2 (recommended) mode.
Confirmation message will appear. Select OK to complete the settings.
Note(s)
●For a wireless network with authentication setting, key icon appears to the right hand of the SSID.
●Signal icon shows the strength of the signal.
●WEP*2 / WPA key appears as asterisks on the confirmation screen.
●The wireless LAN supports following specifications.
–Wireless standards: IEEE 802.11 b/g/n
–Frequency spectrum: 2.4GHz
–Security protocol: WEP*2 / WPA / WPA2
Continued on next page.