Philips DVD741VR owner manual First-time DVD/VCR Setup, Turn on the TV, Press DISC/MENU

H9231CD(EN).QX3 02.9.5 7:13 PM Page 15

First-time DVD/VCR Setup 15

Before turning on your DVD/VCR, make sure batteries are in the remote control and the DVD/VCR and TV are connected correctly.

●You cannot program channels if you are using a Cable Box or a Direct Broadcast System.

1 Press VCR, then press POWER y. “P-ON” will appear briefly on the front of the DVD/VCR.The green VIDEO light, the VCR/TV light, and the Power light will appear on the front of the DVD/VCR.

Turn on the TV. Set it to the same channel as the
CH3/CH4 switch on the back of the DVD/VCR. The
2 display shown below will appear. (If the display does not
appear, check your hookups, then follow the steps on page
24 to set up channels and page 29 to select a language.)
SELECT op
→ ENGLISH	ON
FRANCAIS
ESPAÑOL

2 Turn on the TV.

			POWER
	MARKER
	SETUP	AUDIO SUBTITLE	ANGLE
5	REC/OTR	REPEAT	REPEAT
			A-B
		CHANNEL/SKIP
		CLEAR
	TITLE	MODE	RETURN
		OUTPUT SELECT
4	DVD		VCR
	DISC
	MENU		OK
	STOP		PLAY
	REW		FF

1

3

PAUSE

MAKE SELECTION OR

PUSH MENU TO CONTINUE

	Within 60 seconds, press PLAY B (o) or STOP C
	(p) to select English, French, or Spanish as the lan-
3 guage for VCR on-screen displays and menus.
4	Press DISC/MENU.
	CONNECT ANTENNA OR CABLE
	TO VCR

THEN...

PUSH CH UP KEY

OR...

FOR PLAY ONLY - PUSH STOP

5 Within 60 seconds, press CHANNEL/SKIP G (o) to begin automatic channel programming. AUTO CH PROGRAMMING IN PROCESS PLEASE WAIT will appear on the TV screen.The DVD/VCR will memorize all available channels.When all channels are memorized, CHANNELS ARE SET will appear on the screen briefly, then TV programming will appear.

These channels will be available when you want to watch TV while in VCR mode.To put the DVD/VCR in VCR mode, press OUTPUT SELECT so the green VIDEO light appears.Then press VCR/TV so the VCR/TV light appears. Press the VCR button, then use CHANNEL/SKIP j/i (p/o) and the Number buttons to select a TV channel for viewing.

TIMER SET

1 2 3

VCR/TV

4 5 6

MEMORY

7 8 9

SPEED

+10 0

SEARCH MODE DISPLAY ZOOM SLOW

TIME SEARCH STATUS/EXIT

Helpful Hints

•To skip this feature and play a tape immediately, insert a tape with its record tab removed.

•To skip step 3, press DISC/MENU. All on-screen displays will be in English.To skip step 5, press STOP C (p). Channels will not be pro- grammed, and CHANNELS NOT SET will appear on the screen.

•If you try to program channels when there is no antenna or Cable TV signal connected to the ANT-IN jack of the DVD/VCR, programming will appear to take place, but even- tually a NO TV SIGNALS message will appear. Connect an antenna or Cable TV signal to the DVD/VCR’s ANT-IN (Antenna In) jack and press CHANNEL/SKIP G (o) again. If channel programming does not resume, follow the steps on page 24.

•You may need to repeat the steps on this page if the power fails.