Philips DVD741VR Timer Recording cont’d, Press two Number buttons for the hour you want

H9231CD(EN).QX3 02.9.5 7:13 PM Page 35

Timer Recording (cont’d) 35

4 Use the Number buttons (1-8) to select a slot in which to store the timer recording. There are eight slots. Numbers for open slots will flash on the screen.

NOTE: If you enter a number for a slot that has already been used to store a timer recording, PREVIOUSLY SET PROGRAM will appear on the screen briefly. Information about the program in that slot will appear on the screen. If this happens, press DIS- PLAY/STATUS/EXIT, then select another number.

5 Use the Number buttons to enter the TV channel you want to record.

●Cable TV Users, enter channel numbers as a two-digit number for the quickest results. For example, to select channel 6, press 0,6. If you only press the Number 6 but- ton, channel 6 will be selected after a brief delay. There also may be a brief delay when you select channels 10, 11, and 12. If you want to select channels 100 and above, enter channel numbers as a three-digit number. For example, to select channel 117, press 1, 1, 7.

●Antenna Users, enter channel numbers as a two-digit number for the quickest results. For example, to select channel 5, press 0,5. If you only press the Number 5 but- ton, channel 5 will be selected after a brief delay.You may only select channels 2-69.

●If you are recording from line input, press 0,0 to select AV REAR. See Helpful Hints below.

●If you are using a Cable Box/DBS, select the Cable Box/DBS output channel (03 or 04). Set the Cable Box/DBS to the channel you want to record. Leave the Cable Box/DBS on for the timer recording. Details are on page nine.

	Press two Number buttons for the hour you want
	the recording to begin. Press two Number buttons
6 for the minute you want the recording to begin.
	Press 1 for AM or 2 for PM. For example, for 9:30 PM,
	press 09, 30, 2.
	ONE TIME PROGRAM
	PROGRAM	1
	CHANNEL	10
	TIME ON	– – : – –
	TO CORRECT PUSH CLEAR
	TO END PUSH EXIT
7	Follow the instructions in step 6 to enter the record-
	ing’s stop time. (AM or PM will be set automatically.)
	ONE TIME PROGRAM
	PROGRAM	1
	CHANNEL	10
	TIME ON	09:30 PM
	TIME OFF	– – : – –

TO CORRECT PUSH CLEAR

TO END PUSH EXIT

Instructions continue on page 36.

4-7

POWER

MARKER

SETUP AUDIO SUBTITLE ANGLE

REC/OTR	REPEAT	REPEAT
		A-B
	CHANNEL/SKIP
	CLEAR
TITLE	MODE	RETURN

OUTPUT SELECT

DVDVCR

DISC

MENUOK

STOP		PLAY
REW		FF
	PAUSE
		TIMER SET
1	2	3
		VCR/TV
4	5	6
		MEMORY
7	8	9
		SPEED
+10	0
SEARCH MODE DISPLAY		ZOOM SLOW
TIME SEARCH	STATUS/EXIT

Helpful Hints

•Entries that do not match the DVD/VCR’s clock or calendar will cause a question mark to appear on the screen.

•If you are recording from line input, connect the audio and video cables to the AUDIO IN and VIDEO IN jacks on the back of the DVD/VCR. (Please see illustration on page 38.)

•The +10 Number button has no effect in VCR mode, so do not use it to enter TV channel numbers at step 5.