Record on Hard Disk (continued)
About timer recording
Use the timer recording to automatically start and stop a recording at a later date/ time. This recorder will tune to the right programme channel and begin recording at the specified time.
With this recorder, you can programme up to 8 recordings at a time. During timer recording, changing the recorder’s channel is not possible.
To make a timer recording, your recorder needs to know:
–The date you want to make the recording.
–The recording input source.
–The start and stop time of the recording.
TIMER
OK
CLEAR 
About ‘VPS/PDC’
‘VPS’ (Video Programming System) or ‘PDC’ (Programme Delivery Control) is used to control the start and duration of TV channel recordings. If a TV programme starts earlier or ends later than was scheduled, this recorder will then turn on and off at the correct time.
VPS/PDC is intended to record the entire programme. To set a time that is longer/ shorter than the VPS/PDC broadcast time, you must turn off the VPS/PDC.
Timer recording (VIDEO Plus+® System)
This is a simple timer programming system. To use it, enter the VIDEO Plus+® programming number associated with your television programme. You can find this number in your TV listings magazine.
All the information needed by this recorder for programming is contained in the programming number.
ATurn on the TV to the correct programme number for the recorder (e.g. ‘EXT’, ‘0’, ‘AV’).
BTurn on the recorder and press TIMER on the remote control.
The timer menu appears.
TIMER
Video Plus+ System
Timer Setup
Timer List
To EXIT, Press TIMER
CSelect { VIDEO Plus+® System } in the menu and press OK.
The VIDEO Plus+® entry menu appears.
Enter code | Video Plus+ System |
| |
Repeat | None |
VPS/PDC |
|
Continue
Press OK to select
To exit Press TIMER
TIPS: Set the appropriate recording mode for HDD recording. The same recording mode will be used for recording from HDD to a recordable DVD, see page 29.
34
dvdr3300h_uk_eng_17233d.indd 34 |