Philips DVDR3330H Access Control, Level, Set Country, Status Display, Resume, Adapt Disc Menu

Setup Menu Options (continued)

Feature settings (underlined options are the factory default settings)

Access Control

	Parental Level
Enter Code
	[ ] [ ] [ ] [ ]
Level: Off
Set Country	Austria

Press SETUP to save and exit.

This is to prohibit viewing of discs that had exceeded the limits you set. Before you can set the parental level or country, you must set a four-digit pin code. Press OK to access.

{ Enter Code } – When doing this for the first time, use the numeric keypad 0-9on the remote control to enter any four-digit you prefer. You must enter the same pin code a second time to confirm it.

	– If you forget your four-digit pin code, press
	STOP „ four times to revert to default pin code
	‘0000’ and enter any four-digit you prefer.
{ Level }	– It works only on the DVDs with parental level
	assigned to the complete disc or to certain scenes
	on the disc. Use W X keys to select a rating level
	from 1 to 8. The ratings are country-dependent
	(‘1’ is considered material that is least offensive
	and ‘8’ is most offensive). DVDs that are rated
	higher than the level you selected will not play
	unless you enter your four-digit pin code.
	– To disable parental controls and allow all discs to
	play, select ‘0ff’.
{ Set Country }	– The Parental control levels depend on the
	country in which the DVD was manufactured.
	Therefore, it is necessary to select a geographic
	area as the playback limitation level.

Status Display	Display the information about the current state of the recorder. Press OK
	to select:
		– The current operating information will be
		displayed for few seconds.
		– Turns off the status display.
Resume	With this feature, you can resume playback of the disc from where it last
	stopped. This applies to the last 20 DVDs,Video CDs and HDD titles you
	played. Press OK to select:
		– Turns on auto resume mode.
		– The disc will always start from the beginning
		when you load a disc or start playback.
Low Power Standby	This is an energy saving mode. Press OK to select:
		– When you switch the recorder to standby mode,
		the display panel will turn blank to save power.
		– Clock will display on the recorder’s display panel
		when switching off to standby mode.
	This option is only visible when you load a DVD±R/±RW that was
Adapt Disc Menu
	recorded in another recorder. Make sure that the recorder is in stop
	mode with no disc menu displayed on the screen, see page 51.
PBC Enable	This option is only visible when a VCD/SVCD is in the disc tray.

dvdr3300h_uk_eng_17233d.indd 59

59

2005-10-31 4:27:58 PM