Philips DVDR5330H, DVDR3300H, DVDR3330H manual Troubleshooting, No power

Page 63

Troubleshooting

WARNING

Under no circumstances should you try to repair the system yourself, as this will invalidate the warranty. Do not open the system as there is a risk of electric shock.

If a fault occurs, first check the points listed below before taking the system for repair. If you are unable to remedy a problem by following these hints, consult your dealer or Philips for help.

Problem

Solution

 

 

No power.

The message “IS TVON?” appears on the display panel.

The recorder does not respond.

Remote control does not work.

No picture.

No sound.

SAT (satellite) recording does not occur.

–Press the STANDBY-ON button on the front of the recorder to turn on the system.

–Make sure the AC outlet has power.

–The recorder will not operate until you complete the basic installation. Read chapter “Step3: Installation and Set-up” for details.

–There is a technical problem. Disconnect the recorder from the power outlet for 30 seconds, then connect again. If the recorder still will not operate, then reset it to the default factory settings:

1)Disconnect the recorder from the power outlet.

2)Press and hold down STANDBY-ON button on the front of the recorder while reconnecting to the power outlet.

3)Release STANDBY-ON button when “IS TVON?” appears on the display. All the information stored in the memory (programmes, time) will be cleared. You may need to reset the recorder settings after completing the basic installation.

–Aim the remote control directly at the sensor on the front of

the recorder (not towards TV). If the recorder receives a signal from the remote control, the icon D will appear on the display.

–Remove any obstacles between the recorder and remote control.

–Batteries are weak. Replace the batteries.

–Turn on your TV and set to the correct Video In channel for the recorder. You may go to Channel 1 on your TV, then press the channel down button on your TV’s remote control until you see the TV programme.

–Check the video connection between the recorder and the TV.

–Check the recorder audio connection. Read chapter “Basic Recorder Connections - Connecting the audio cables” for details.

–Set the Analogue output or Digital output correctly, based on the device you have connected to the recorder. Read chapter “Setup Menu Options - Sound settings” for details.

–Check the { Low Power Standby } option is set to ‘Off’ in the { Feature } setting.

–Check the { SAT record } option is set to ‘On’ in the { Recording } setting.

–Make sure that the Satellite Receiver is connected to the EXT 2 AUX-1/O scart socket.

63

dvdr3300h_uk_eng_17233d.indd 63

2005-10-19 10:41:31 AM

Page 62 Page 64
Image 63
Page 62 Page 64
Contents HDD & DVD Player / Recorder Mains plug How to connect a plugFor Customer Use Serial NoKlass 1 laseraparat Dvdr3300hukcover17232.indd Laser Table of Contents Display panel symbol/messages Additional Playback FeaturesSetup Menu Options Firmware Upgrade‘Instant Replay’ Special Features‘Time Shift Buffer’ ‘FlexTime’Frequently Asked Questions HDD Hard Disk Drive handling care Care and Safety InformationSetup precautions Cleaning discsRegion codes Accessories suppliedGeneral Information IntroductionRemote Control Select Numeric keypadHDD DVDInserting Batteries Using the remote control to operate the systemSockets behind the flap Main UnitBasic Recorder Connections Connecting the aerial cablesOption 3 Using the Video Cvbs socket good picture quality Connecting the video cableOption 1 Using the Scart socket best picture quality Option 2 Using the S-Video socket excellent picture qualityReceiver with two-channel digital stereo PCM Connecting the audio cablesOption 1 Using the analogue audio sockets Option 2 Using the digital audio socket Optical or CoaxialOptional Connections Connecting to a Cable Box or Satellite ReceiverHelpful Hints Connecting to a VCR or other similar deviceTV OUT or to VCR on the Cable Box/ Satellite Receiver Connecting to a VCR and Cable Box/Satellite ReceiverOption 1 Using the DV in socket Connecting to a camcorderOption 2 Using the S-VIDEO In or Video In socket Installation and Set-up Channels appear Press OK to start automatic channel installInstant Replay function Switching on to TV programmeControl TV Programmes Pause live TV functionBefore Recording Time Shift video bar consists of the following informationYou can mark up to a maximum Default recording settings Press To access its optionsPress Sport Record ModeFilter Mode StandardRecord on Hard Disk Recording TV programmesSimultaneous record and play function Watching other TV programmes Automatic recording from a Satellite ReceiverTurn on the TV to the correct Camcorder to pause modeRemote control Recording from a DV camcorderInput the total recording time Recording from an external device Camcorder/VCR/ DVD playerAbout ‘VPS/PDC’ About timer recordingTimer recording Video Plus+ System To make a timer recording, your recorder needs to knowRepeat Press Timer to confirm and exit the menuKeys to move to Timer recording manuallyUse 9to select or enter the recordingProgramme which you want to delete/ change Changing/Deleting a timer recordingTo change the timer entry, press OK To cancel the timer programmingRecord on DVD Recordable Disc Discs for recordingAbout copying Recording to a recordable Before you startRecordable DVD in the menu and press OK Basic operation Playback from Hard DiskPlayback from Disc Playable discsStarting disc playback Playing an MP3 CD Playing a DVD video discPlaying a Super Video CDs Playing a DVD recordable discPlaying a picture disc slide show Using the Play Mode options Additional Playback FeaturesZooming Using the T/C optionsUse ST keys to select an option in the menu Selecting a title/chapterSearching by time Switching camera anglesSwitching to slow motion play Switching to step playbackSelecting sound mode Changing the audio soundtrack languageChanging subtitle language Changing the title name Using the HDD edit title menuTo remove the protect feature Edit Recordings HDDFor Copy to Recordable DVD , see Using the HDD edit scene menuOtherwise, select Cancel and press OK to abort Deleting a title from HDDDivide Title Delete MarkerInsert Marker Delete AllMaking the DVD±R/±RW compatible with this recorder Editing Recordings Recordable DVDAbout recordable DVD editing Index Picture screenProtecting the disc Using the disc settings menuChanging the disc name Press OK to confirm the changes and press W to exitFinalising the DVD±R for playback Disc Settings menu, selectErasing disc DVD±RW only Making the edited DVD±RW compatibleUsing the title settings menu Playing the entire title including the hidden scenesErasing title Using the edit chapters menu Accessing the Setup Menu Setup Menu Options169 TV ShapeLetterbox PanScanAnalogue Output Night ModeDigital Output PCM onlySet Country Access ControlPBC Enable LevelEntry/Search Auto InstallFine Tuning Manual SearchDelete TV channel Time & DateInstalling the latest firmware Firmware UpgradeNo power TroubleshootingDvdr3300hukeng17233d.indd 2005-10-19 104132 AM Minutes, SEP 30 minutes Recorded DVD cannot be played back on another DVD playerNot able to access Specifications PCM Pulse Code Modulation. a digital audio encoding system Glossary0000 Display panel symbol/messagesDvdr3300hukback17232.indd 2005-10-19 103948 AM TV System Guide Libya Secam B Secam G Lithuania 3139 246 DVDR3300H DVDR3330H DVDR5330H
Top Page Image Contents