Philips VR 510/07 Selecting tape position display type, Special Settings, Confirm

MAIN MENU

CLOCK

AUTO INSTALL

MANUAL SEARCH

TV CHANNEL ALLOC.

RECORD SPEED

AUTO STANDBY

TV SYSTEM

SPECIAL SETTINGS

OK

SPECIAL SETTINGS

OSD	ON
CLOCK DISPLAY	OFF
COUNTER	QT.LEFTP
SAT RECORDING	OFF
REPEAT PLAY	OFF
	OK

Selecting tape position display type

If the OK button is pressed during playback and recording, the current tape position (hours : minutes : seconds) is shown in the display.There are two different types of display available.

1Press the MENU button on the remote control.The on-screen menu appears

2Use =P- or ;P+ to select the option

“SPECIAL SETTINGS”	and	confirm
with OK

3Use =P- or ;P+ to select the option “COUNTER”

What types of display are available to me?

“LINEAR”:	The display shows the number of
	minutes of tape already played
	(00:00:00 - hours/minutes/seconds)
“TIME LEFT”:	The display shows the playing time
	remaining until the end of the	PARDON?
	cassette (00:00 - hours/ minutes)

4Use S+ P or QS- to select the desired display type and confirm with OK.The screen will show the message “STORED”

8The counter stops running when unrecorded places are found (“Linear” display type)

4 This is normal, and is necessary for technical reasons.

8The display shows a negative playing time

4This may happen, for example, when you insert an incompletely-rewound cassette into the video recorder and rewind it to the start of the tape. Since the display is automatically reset to “00:00:00” when you insert a cassette, the actual start of the cassette for the set is less than zero - thus in the negative range.The tape position is displayed with a minus sign “-”.

8After inserting a cassette the video recorder shows no remaining playing time

4The set needs a little time to calculate the remaining playing time. After a few seconds, the display should

change from “--:--” to the corresponding value PROBLEM

ENGLISH 19 SELECTING TAPE POSITION DISPLAY TYPE