Philips VR 510/07 operating instructions Important information for customers in Great Britain

Important information for customers in Great Britain

This set is fitted with an approved moulded 13 amp plug.To change the fuse in this plug or to attach a different plug, please proceed as follows:

1Take off the fuse cover and remove the old fuse

2Insert a new fuse. Suitable fuses are those of the type BS 1362 3A, A.S.T.A. standard or BSI standard

3Close the fuse cover

If the attached plug does not meet your requirements, you can cut it off and replace it with a suitable plug. Please observe the following conditions:

If your new plug uses a built-in fuse, this should be a 3A fuse.

If your new plug does not contain a built-in fuse, please do not use any fuses in your fusebox with a rating of more than 5A.

Please destroy the old, cut-off plug so that it cannot be used elsewhere.

4Connect the blue cable (neutral “N”) to the terminal in the plug which is marked with the letter “N” or coloured black

5Connect the brown cable (live,“L”) to the terminal in the plug which is marked with the letter “L” or coloured red

6Do not in any circumstances connect either of the two cables to the terminal

in the plug which is marked with the letter “E”, the symbol “ \” or coloured green or green / yellow

!Before you refit the plug cover, make sure, that the grip at the bottom of the plug is clamped over the plastic cover of the lead, not just over the two wires.

IMPORTANT INFORMATION FOR CUSTOMERS IN GREAT BRITAIN 6 ENGLISH