The base frame assembly is complete. Set it aside for use in a later step.
2Assemble the seat frame.
ALocate the footrest wire frame with connecting hubs. Place it on a flat surface with the toy bar sockets pointing upward as shown.
Connecting
hub
Backrest wire frame
Sockets
pointing upward
Connecting
hub
Footrest wire frame
BLocate the backrest wire. Position it so that the wire ends are near the connecting hubs.
CPartially insert both left and right ends of the backrest wire into the corresponding sockets in the connecting hubs. (Stop just before either
NOTE: To avoid binding, do not fully insert one wire end before inserting the other end.
DPress the spring- loaded button on the
left end of the backrest wire and fully insert it into the connecting hub. Verify that the button fully engages, latching the wire frame to the hub.
ERepeat Step D for the right end of the backrest wire.
3Connect the seat frame to the base frame.
A Hold the seat frame in position above the base frame. Prepare for assembly by verifying that:
• the toy bar sockets on the connecting hub point upward, and...
• the wire ends on the base frame point toward the corresponding holes in the connecting hubs.
BPartially insert both left and right ends of the base frame wire into the holes in the connecting hubs. (Stop
just before either spring-
loaded button enters the
hub.)
C Press the
backrest wire and fully insert the wire into the connecting hub. Verify that
the button fully engages, locking the wire frame into
the hub.
D Repeat Step C for the right end of the base frame wire.
E Inspect both connecting hubs to verify that the
frame wires are fully
inserted. Be sure that the two
The bouncer frame assembly is complete.
4Attach the seat pad to the seat frame.
CAUTION: Adjust the wiring as needed to keep it away from the
CorrectIncorrect
– 2 –