6Install the vibration unit.
A Position the vibration unit with the Mounting groove mounting groove on top.
BInstall the vibration unit by doing the following:
•Insert the rear of the unit into the opening in the seat pad.
•Slide the mounting groove of
the vibration unit onto the
•Push the vibration unit onto the frame until its front panel is flush with the seat pad.
Mounting location
in footrest wire
frame
Vibration
unit
7
FGuide the toy bar power connector through the opening in the seat pad. Plug it into the receptacle in the rear of the vibration unit.
Opening in seat pad | Connector |
| Wiring |
NOTE: The power connector is polarized (only plugs in one way).
GReturn the bouncer to the upright position.
Mount the toy bar to the bouncer frame.
ALocate the plush sun/mirror toy and Baby Newton™ (soft plastic lion).
B Attach each toy | Rings under toy bar | |
to the toy bar. Use | ||
| ||
the opening in the |
| |
large ring to |
| |
attach each toy to |
| |
a ring under toy |
| |
bar. |
|
CGently tilt the bouncer frame over until the backrest contacts the floor or surface.
DFasten the pair of hook-
ESlide the
NOTE: The opening in the seat pad allows you to connect or disconnect the power cable without unfastening the seat pad. This makes it easier to change the batteries in the vibration unit.
Hook-and-loop patches
Fabric loop
Hook-and-loop strap
COrient the toy bar
with the caterpillar’s head toward the right side of the frame (child’s left).
D Plug each end of the toy bar into the corre- sponding socket in the connecting hub.
NOTE: The toy bar end nearest the caterpillar head has
Congratulations! The lights and melodies bouncer assembly is complete.
– 4 –