Denon AVR-5700 manual Multi-source and multi-zone playback, Multi Room Music Entertainment System

Page 42

Multi-source and multi-zone playback

MULTI ROOM MUSIC ENTERTAINMENT SYSTEM

When the outputs of the MULTI SOURCE AUDIO OUT terminals are wired and connected to integrated amplifiers installed in other rooms, different sources can be played in rooms other than the main room in which this unit and the playback devices are installed. (Refer to ANOTHER ROOM on the diagram below.)

When a sold separately room-to-room remote control unit (DENON RC-616, 617 or 618) is wired and connected between the main room and

another room, the remote-controllable devices in the main room can be controlled from another room using the remote control unit.

2To control playback devices other than the ones above, either use that device’s remote control unit or preset a separately sold programmable remote control unit.

NOTES:

For the AUDIO output, use high quality pin-plug cords and wire in such a way that there is no humming or noise.

For instructions on installation and operation of separately sold devices, refer to the devices’ operating instructions.

MULTI ROOM MUSIC ENTERTAINMENT SYSTEM

ANOTHER ROOM

MAIN ROOM

 

 

 

RC-617

INTEGRATED

 

AMPLIFIER

 

PROGRAMMABLE

AVR-5700

REMOTE

 

CONTROL UNIT

 

 

 

 

 

 

SYSTEM REMOTE

RC-616

 

 

 

 

CONTROL UNIT RC-853

 

 

 

ROOM-TO-ROOM REMOTE CONTROL SYSTEM (separately sold) control line

MULTI SOURCE AUDIO signal cable

SPEAKER cable

2Refer to CONNECTIONS on pages 6 to 13.

Room to Room Remote Control jacks

The OUT jack is an extension jack for future use.

When the OUT jack is connected, the signals input to the IN jack are output from the OUT jack directly. (Example: RC616 signals are output.)

Do not connect only the OUT jack.

(The signals from the AVR-5700’s remote sensor are not output to this jack.)

42

Image 42
Contents AVR-5700 Safety Precautions Safety Instructions Table of Contents Before UsingFeatures Connecting the audio components ConnectionsConnecting video components Connecting a monitor TV Connecting a video component equipped with S-Video jacksPrecaution when using S-jacks Connecting the video decksConnecting the antenna terminals AM loop antenna assemblyConnection of AM antennas Connecting a DVD player DVD in jacks Connecting a monitor TV Monitor OUT jackConnecting the external input EXT. in jacks Connecting the Multi Source jacksSpeaker Impedance Connecting the speaker cordsSpeaker system connections ConnectionsProtector circuit Part Names and Functions Front PanelRemote control unit Power button …………………………36 Tuner buttons …………………………52Surround Parameter button Setting UP the SystemSystem Setup button Enter buttonSurround speaker selector function Before setting up the system Setting the type of speakersSystem Setup Menu reappears Setting the bass outputEnter the setting At the System Setup Menu select Bass OutputAt the System Setup Menu select Delay Time Setting the delay timeSubwoofer Only THX recommended THX mode Front & SubwooferSelect the desired unit, meters or feet Select darken the desired units, Meters or FeetSetting the channel level Test tone A, B or A+BSurr. Sp. a Volume can be adjusted between -12 dB and +12 dB in units When the Manual mode is selectedChannel Level screen reappears Subwoofer peak limit level setting AVR-5700 automatically sets the subwoofer peak limit levelSetting the digital inputs Setting the on-screen display OSD Auto tuner presetsAfter completing system setup On-screen display signalsRemote Control Unit Using the remote control unitInserting the batteries Operating Denon audio components Set mode switch 2 to the position for the component to beOperated. The tuner can be operated when the switch is at Any position but LockPreset memory VCR VCR or TV Operating a video component stored in the preset memorySet the slide switch to the component to be registered VDP Operate the video componentLearning function Using the system call function System call functionSystem call buttons Storing signals Clearing system call settingsOperation Before operatingPlaying the input source Select the input mode Selecting the analog modeInput mode selection function Select the input source to be playedAdjust the volume Select the play modeManual Auto mode Digital Auto mode Digital PCM mode Input mode when playing DTS sourcesAfter starting playback Adjusting the sound quality toneListening over headphones Turning the sound off temporarily mutingPlaying one source while recording another REC OUT mode Multi-source recording/playbackPlayback using the external input EXT. in jacks Multi-source and multi-zone playback Multi Room Music Entertainment SystemAdjust the level of the selected speaker SurroundBefore playing with the surround function Dolby Surround Pro Logic mode Fader functionSelect the Dolby Surround mode Set the input mode to Auto or RFSet the input mode to Auto or Digital DTS indicator lights when playing DTS sourcesLFE Low Frequency Effect Surround parameters Cinema EQ. Cinema EqualizerCOMP. Dynamic Range Compression Dialogue NormalizationHome THX Cinema mode Surround modes and their features DSP Surround SimulationPersonal Memory Plus Select the surround mode for the input channel DSP surround simulationWide Screen can only be selected from the main unit Tone control setting Select ToneSurround parameters Surround modes and parametersAuto tuning Manual tuningListening to the Radio Checking the preset stations Recalling preset stations Last Function MemoryInitialization of the Microprocessor Troubleshooting Optimum surround sound for different sources Types of multi-channel signalsAdditional Information Types of sources Movie audioSpeaker setting examples Basic setting for primarily watching moviesWhen using different surround speakers for movies and music 2Dolby Digital and Dolby Pro Logic SurroundDolby Surround Dolby Digital Dolby Surround AC-3 Dolby Digital compatible media and playback methodsDTS Digital Surround Dolby Pro LogicDTS compatible media and playback methods Timber matching circuit Home THX Cinema surround modeRe-equalizer Dynamic decorrelation circuitSurround modes and parameters AUX TAPE-1Specifications Audio section Power amplifier Rated outputPage 14-14, Akasaka 4-CHOME, MINATO-KU, Tokyo 107-8011, Japan