Denon Comprehensive Guide to Play Modes for AVR 5700 Stereo Receiver

Select the play mode.

Input mode display

3	Example: Stereo
	STEREO	STEREO
	(Main unit)	(Remote control unit)
4	Start playback on the selected component.
	• For operating instructions, refer to the component’s
	manual.

•In the AUTO mode

•In the DIGITAL AUTO mode

•In the DIGITAL PCM mode

One of these lights, depending on the input signal.

ANALOG DIGITAL

DIGITAL

DIGITAL

5	Adjust the volume.	MASTER VOLUME
			MASTER VOL.
	The volume level is	(Main unit)	(Remote control unit)
	displayed on the
	master volume level
	display.

2The volume can be adjusted within the range of –60 to 0 to 18 dB, in steps of 1 dB. However, when the channel level is set as described on page 22 or pages 43 and 44, if the volume for any channel is set at +1 dB or greater, the volume cannot be adjusted up to 18 dB. (In this case the maximum volume adjustment range is “18 dB — (Maximum value of channel level)”.)

Input mode when playing DTS sources

•Noise will be output if DTS-compatible CDs or LDs are played in the “ANALOG” or “PCM” mode.

When playing DTS-compatible sources, be sure to connect the source component to the digital input jacks (OPTICAL/COAXIAL) and set the input mode to “AUTO” or “DIGITAL”.

• When switched to RF in the VDP RF or AUTO mode

DIGITAL

• In the ANALOG mode

ANALOG

Input signal display

• DOLBY DIGITAL				One of these lights, depending on the
				input signal.
	CH INDICATOR
L	C	R	LOCK		LOCK
SL	S	SR	LFE	DIGITAL	PRO LOGIC
• DTS
	CH INDICATOR			Lit
L	C	R	LOCK		LOCK
SL	S	SR	LFE

• PCM

CH INDICATOR

L C R LOCK

LOCK

SL S SR LFE

2The LOCK LED lights when digital signals are being input properly. If the LED does not light, check whether the digital input component setup (page 25) and connections are correct and whether the component’s power is turned on.

NOTE:

•The digital input indicator will light (green) when playing CD- ROMs containing data other than audio signals, but no sound will be heard.

38