Denon AVR-5700 manual Specifications, Audio section Power amplifier Rated output

Page 62

17 SPECIFICATIONS

2 Audio section

 

 

• Power amplifier

 

 

Rated output:

Stereo (2ch driven)

(All properties shown are only

140

W + 140 W (8 Ω /ohms, 20 Hz ~ 20 kHz with 0.05% T.H.D.)

for the power amplifier stage.)

170

W + 170 W (8 Ω /ohms, 1 kHz with 0.7% T.H.D.)

 

Surround

 

140

W x 5 ch (8 Ω /ohms, 1 kHz with 0.7% T.H.D.)

Dynamic power:

Output terminals:

•Analog

Input sensitivity / input impedance: Frequency response:

S/N:

Distortion:

Rated output/maximum output: Maximum headphones output:

•Digital

D/A output:

Digital input:

•Phono equalizer (PHONO input — REC OUT) Input sensitivity:

RIAA deviation: Signal-to-noise ratio:

Rated output / Maximum output: Distortion factor:

2Video section

•Standard video jacks

Input / output level and impedance: Frequency response:

•S-video jacks

Input / output level and impedance: Frequency response:

•Color component video terminal Input / output level and impedance:

Frequency response:

2Tuner section

Receiving Range:

Usable Sensitivity:

50 dB Quieting Sensitivity:

Signal to Noise Ratio (IHF-A):

Total Harmonic Distortion (at 1 kHz):

2General

Power supply:

Power consumption:

Maximum external dimensions:

Weight:

2Remote control unit (RC-853) Batteries:

External dimensions: Weight:

190 W x 2 ch

(8 Ω /ohms)

310 W x 2 ch

(4 Ω /ohms)

390 W x 2 ch

(2 Ω /ohms)

Front/Center:

16 ~ 16 Ω /ohms

Surround:

A or B 16 ~ 16 Ω /ohms

 

A + B 12 ~ 16 Ω /ohms

200 mV / 47 kΩ /kohms

10 Hz ~ 100 kHz: +0, –3 dB (DIRECT mode) 105 dB (DIRECT mode)

0.005% (20 Hz ~ 20 kHz) (DIRECT mode)

1.2 V / 8 V

284 mW (8 Ω /ohms)

Rated output — 2 V (at 0 dB playback)

Total harmonic distortion — 0.005% (1 kHz, at 0 dB)

S/N ratio — 105 dB

Dynamic range — 96 dB

Format — Digital audio interface

2.5 mV

±1 dB (20 Hz to 20 kHz)

74 dB (A weighting, with 5 mV input)

150 mV / 8 V

0.03% (1 kHz, 3 V)

1 Vp-p, 75 Ω /ohms

5 Hz ~ 10 MHz — +0, –3 dB

Y (brightness) signal —

1 Vp-p, 75 Ω /ohms

C (color) signal — 0.286 Vp-p, 75 Ω /ohms

5 Hz ~ 10 MHz — +0, –3 dB

Y (brightness) signal —

1 Vp-p, 75 Ω /ohms

Cb (blue) signal — 0.7 Vp-p, 75 Ω /ohms

Cr (red) signal — 0.7Vp-p, 75 Ω /ohms

5 Hz ~ 20 MHz — +0, –3 dB

[FM] (note: µV at 75 Ω /ohms, 0 dBf = 1 x 10–15W) [AM]

87.5 MHz ~ 107.9 MHz

520 kHz ~ 1710 kHz

1.0 µV (11.2 dBf)

18 µV

MONO

1.6 µV (15.3 dBf)

STEREO

23 µV (38.5 dBf)

MONO

80 dB

50 dB

STEREO

75 dB

 

MONO

0.15%

 

STEREO

0.3%

 

AC 120 V, 60 Hz 11 A

434 (W) x 181 (H) x 494 (D) mm (17-3/32” x 7-1/8” x 19-29/64”) 21.5 kg (47 lbs 6 oz)

R6P/AA Type (two batteries)

70 (W) x 215 (H) x 24 (D) mm (2-3/4” x 8-15/32” x 15/16”) 200 g (Approx. 7 oz) (including batteries)

* For purposes of improvement, specifications and design are subject to change without notice.

62

Page 61 Page 63
Image 62
Page 61 Page 63
Contents AVR-5700 Safety Precautions Safety Instructions Table of Contents Before UsingFeatures Connecting the audio components ConnectionsConnecting video components Connecting a monitor TV Connecting a video component equipped with S-Video jacksPrecaution when using S-jacks Connecting the video decksConnection of AM antennas Connecting the antenna terminalsAM loop antenna assembly Connecting a DVD player DVD in jacks Connecting a monitor TV Monitor OUT jackConnecting the external input EXT. in jacks Connecting the Multi Source jacksSpeaker Impedance Connecting the speaker cordsSpeaker system connections ConnectionsProtector circuit Part Names and Functions Front PanelRemote control unit Power button …………………………36 Tuner buttons …………………………52Surround Parameter button Setting UP the SystemSystem Setup button Enter buttonSurround speaker selector function Before setting up the system Setting the type of speakersSystem Setup Menu reappears Setting the bass outputEnter the setting At the System Setup Menu select Bass OutputAt the System Setup Menu select Delay Time Setting the delay timeSubwoofer Only THX recommended THX mode Front & SubwooferSelect the desired unit, meters or feet Select darken the desired units, Meters or FeetSurr. Sp. a Setting the channel levelTest tone A, B or A+B Channel Level screen reappears Volume can be adjusted between -12 dB and +12 dB in unitsWhen the Manual mode is selected Subwoofer peak limit level setting AVR-5700 automatically sets the subwoofer peak limit levelSetting the digital inputs Setting the on-screen display OSD Auto tuner presetsAfter completing system setup On-screen display signalsInserting the batteries Remote Control UnitUsing the remote control unit Operating Denon audio components Set mode switch 2 to the position for the component to beOperated. The tuner can be operated when the switch is at Any position but LockPreset memory VCR VCR or TV Operating a video component stored in the preset memorySet the slide switch to the component to be registered VDP Operate the video componentLearning function System call buttons Using the system call functionSystem call function Storing signals Clearing system call settingsOperation Before operatingPlaying the input source Select the input mode Selecting the analog modeInput mode selection function Select the input source to be playedAdjust the volume Select the play modeManual Auto mode Digital Auto mode Digital PCM mode Input mode when playing DTS sourcesAfter starting playback Adjusting the sound quality toneListening over headphones Turning the sound off temporarily mutingPlaying one source while recording another REC OUT mode Multi-source recording/playbackPlayback using the external input EXT. in jacks Multi-source and multi-zone playback Multi Room Music Entertainment SystemBefore playing with the surround function Adjust the level of the selected speakerSurround Dolby Surround Pro Logic mode Fader functionSelect the Dolby Surround mode Set the input mode to Auto or RFSet the input mode to Auto or Digital DTS indicator lights when playing DTS sourcesLFE Low Frequency Effect Surround parameters Cinema EQ. Cinema EqualizerCOMP. Dynamic Range Compression Dialogue NormalizationHome THX Cinema mode Personal Memory Plus Surround modes and their featuresDSP Surround Simulation Wide Screen can only be selected from the main unit Select the surround mode for the input channelDSP surround simulation Tone control setting Select ToneSurround parameters Surround modes and parametersListening to the Radio Auto tuningManual tuning Checking the preset stations Initialization of the Microprocessor Recalling preset stationsLast Function Memory Troubleshooting Optimum surround sound for different sources Types of multi-channel signalsAdditional Information Types of sources Movie audioWhen using different surround speakers for movies and music Speaker setting examplesBasic setting for primarily watching movies 2Dolby Digital and Dolby Pro Logic SurroundDolby Surround Dolby Digital Dolby Surround AC-3 Dolby Digital compatible media and playback methodsDTS compatible media and playback methods DTS Digital SurroundDolby Pro Logic Timber matching circuit Home THX Cinema surround modeRe-equalizer Dynamic decorrelation circuitSurround modes and parameters AUX TAPE-1Specifications Audio section Power amplifier Rated outputPage 14-14, Akasaka 4-CHOME, MINATO-KU, Tokyo 107-8011, Japan
Top Page Image Contents