ASSEMBLY INSTRUCTIONS
Place all parts from the box in a cleared area and position them on the floor in front of you. Remove all packing materials from your area and place them back into the box. Do not dispose of the packing materials until assembly is completed. Read each step carefully before beginning. If you are missing a part please call our
(66)High Tension Spring, red marked | |
| (67)Medium Tension |
| Spring, yellow marked |
| (68)Low Tension |
(67)Medium Tension | Spring, blue marked |
| |
Spring, yellow marked |
|
(68)Low Tension |
|
Spring, blue marked |
|
End without color mark | |
Tension |
|
Spring |
|
STEP 1
There are three different levels of tension springs, HIGH TENSION SPRING, RED MARKED(66), MEDIUM TENSION SPRING, YELLOW MARKED(67), and LOW TENSION SPRING, BLUE MARKED(68). Place the CARRIAGE(42) upside down on the floor. Hook the ends of the TENSION SPRINGS(66, 67, 68) without color marks into the positions shown in the illustration. The blue marked springs are in the outside positions, the red marked spring is in the center position, and the yellow marked springs are between the red and blue springs.
HINT: 1. Refer to the inset drawing. Hold the spring in a vertical position and hook it onto the plate on the CARRIAGE(42) as shown.
2. Make sure that the spring is hooked in the direction shown in the inset drawing.
STEP 2
NOTE: There are TENSION SPRING SLEEVES(69) on the springs. Make sure the TENSION SPRING SLEEVES(69) cover on the springs smoothly and stay between the springs and SPRING HOLDER (62).
Attach the SPRING HOLDER(62) to the CARRIAGE BOARD(52) with BUTTON HEAD BOLTS (M6x1x82mm)(84).
7