Storage, Maintenance | Stamina Products 55-5686B specs

OPERATIONAL INSTRUCTIONS

SHOULDER PAD ADJUSTMENT

The posts on the bottom of the SHOULDER PAD SUPPORTS (117, 118) are offset so you can install the supports in two positions. One position is one inch wider to accommodate broader shoulders, another position is for narrower shoulders. To adjust, switch the position of the SHOULDER PAD SUPPORTS(117, 118) and secure with the HANDLEBAR (119).

STORAGE

1.	Store the AeroPilates Pro XP686 in a clean, dry place.
2.	It is recommended that two people be available to move the AeroPilates Pro XP686.

3.To move the AeroPilates Pro XP686: First, attach one of the TENSION SPRINGS(66, 67 or 68) to the EYEHOOK(70) on the SPRING BAR(71) to prevent the CARRIAGE(42) from moving. Second, grasp the HANDRAIL(30) and lift the unit from the back. Third, roll the AeroPilatesPro XP686 on the moving wheels that are attached to the FRONT FRAME(1).

MAINTENANCE

The safety and integrity designed into the AeroPilates Pro XP686 can only be maintained when the AeroPilatesPro XP686 is regularly examined for damage and wear. Special attention should be given to the following:

1.It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.

2.Worn or damaged components should be replaced immediately or the AeroPilatesPro XP686 removed from service until repair is made.

3.Verify that the Warning Label is present and legible. Replace the Warning Label if it is missing or damaged.

4.Verify that the ROPES(63) are properly installed on the PULLEY SETS(40).

5.Check the condition of the ROPES(63) and replace if they are frayed or worn.

6.Check the condition of the TENSION SPRINGS(66, 67, 68). Replace the springs that are damaged.

7.Check the BUNGEE CORD(78) on the CARDIO REBOUNDER(76) for wear. Replace the CARDIO REBOUNDER(76) if the BUNGEE CORD(78) is frayed or worn.

8.Check the PULLEY SETS(40) for excessive wear. Replace worn PULLEY SETS(40).

9.Check the HAND STRAPS(65) for damage. Replace damaged parts.

10.Check the FOAM GRIPS(21), FOAM TUBE(23), SHORT FOAM TUBES(57), and SHOULDER PADS (84) and replace if damaged or worn.

11.Check the GUIDE SPACERS(16) and BUMPERS(19) for looseness or damage and replace any damaged parts.

12.Check the CUSHION(53) and replace if it is damaged or worn.

13.Check and clean the ROLLERS(47) and SIDE ROLLERS(48) and the rolling surfaces on the rails. Clean by wiping with a dry cloth.

14.Only Stamina Products supplied components shall be used to maintain/repair the AeroPilates Pro

XP686.

15.Keep your AeroPilates Pro XP686 clean by wiping with an absorbent cloth after use.