2
2
4
5
How to Assemble Your Stroller
To Open Stroller
1Remove any cardboard inserts or plastic ties used to protect the product during shipment.
2Release the locking latch.
3Unfold, making sure both side locks snap into place.
To Assemble Rear Wheels
1Remove and discard protective plastic sleeve from ends of brake assembly with
rear axle. Place stroller on floor with seat facing down.
2Position brake assembly with rear axle as shown, with brake levers pointing towards stroller handle.
3Push both sides of brake assembly onto rear leg tubes at the same time until spring loaded buttons click into place.
NOTE: Make sure that spring loaded buttons pop through.
CAUTION: If spring loaded buttons DO NOT pop through, front wheel assembly could fall off during use.
4Slide a rear wheel onto the axle then slide a washer onto the axle.
5 | Fit straight part of cotter pin through |
| hole on axle as shown. |
|
6Line up each of the tabs in the hub cap with the slots in the wheel, snap hub cap into place.
7Repeat for second side.
5