Fisher-Price 79701 owner manual Setup Point Harness, Front of the car seat

Page 17

Setup

5-Point Harness

2

1

1Make sure both shoulder straps are inserted into the buckle.

2Lift the harness release lever and pull the shoulder straps out as far as you can on the

front of the car seat.

WARNING

NEVER use the upper burgundy shoulder strap slots with a child in the rear-facing position. The shoulder straps will not be snug against your child and your child will not be prop- erly restrained. Use the lower or middle blue shoulder strap slots when using the car seat rear-facing.

REAR-FACING POSITION BIRTH TO 1 YEAR (6 - 30 LBS.)

16

Image 17

Contents Safe Embrace Table of Contents Message to Parents Page Page Page For Your Information Adds greater strength than car seats with all plastic frames Surrounds your child with an extra layer of protectionEep your child safer Selecting a Vehicle Seating Location For Your Car Seat Use vehicle seats That face the side Vehicle Always use vehicle seats That face the front of the vehicleWhat Kind of Vehicle Belt System Do You Have? You will not be able to keep the car seat secure These Vehicle Belt SystemsLap belt is tightened by pulling on its free end Only USERear-Facing Position Path Opening Rear-Facing Harness Adjustment StrapRear-Facing Position Birth to 1 Year 6 -30 lbs Front of the car seat Setup Point HarnessMake sure both shoulder straps are inserted into the buckle Setup Point Harness Shoulder strap slots Position only if your child’s shoulders are at Pull the connector bar up on the back of the car seat Bottom of the car seat B Setup Seat Position ReclineClose the connector bar cover. REAR-FACING Never install and restrain a child Installing Your Car Seat in a VehicleSee inset will help keep it clean Car seat Buckle the vehicle belt Begins to rise 5B For a manual lap belt system Correct Installing Your Car Seat in a Vehicle Installing Your Car Seat in a Vehicle Correct Incorrect Restraining Your Child Insert each of the shoulder straps into Position the crotch strap between your Child’s legsRestraining Your Child Restraining Your Child Insert both shoulder straps into the buckle To remove your child from the car seatForward-Facing Position Forward-Facing Strap Slots Tether StrapBelt Path HarnessTether Anchor Tether Strap Tether Anchor InstallationTether Anchor Tether Strap Tether Anchor Installation Car Appropriate eye protection when drillingHave to drill a 5/16 hole. Be sure to wear Line of the Safe Embrace ConvertibleIf a pre-drilled hole does not exist, you will Still accessible by the tether strapNo more than 4 from the center line Safe Embrace Convertible Car SeatTether Anchor Installation Pick-Up Truck Setup Point Harness Setup Point Harness Tongue face each other. Fasten the chest clip Setup Point Harness Close the connector bar cover You B Setup Seat-Position UprightPull the seat position adjuster Installing Your Car Seat in a Vehicle Front of Vehicle Opposite side of the car seatBuckle the vehicle belt 4A For a lap and shoulder belt system 4B For a manual lap belt system Installing Your Car Seat in a Vehicle To Remove Correct Metal and plastic parts of the car seat Straps are not twisted Restraining Your Child Buckle the chest clip Restraining Your Child Restraining Your Child Unbuckle the chest clip Consumer Information Aircraft Use Register Your Safe Embrace Convertible Car Seat Not use bleach Cleaning and WashingSeat pad Cleaning and Washing Page Safe Check