Fisher-Price 79701 owner manual Opposite side of the car seat, Front of Vehicle

Page 52

FORWARD-FACING POSITION 1 YEAR AND UP (22 - 40 LBS.)

Installing Your

Car Seat in a Vehicle

1	FRONT OF VEHICLE

2

1Once you have selected an acceptable seat- ing location and have installed the tether

anchor, place the car seat on the vehicle seat facing the front of the vehicle.

2Route the vehicle belt over the bend in the burgundy tube, against the connector bar cover on the back of the car seat and then over the bend in the burgundy tube on the

opposite side of the car seat.

51

Image 52

Contents Safe Embrace Table of Contents Message to Parents Page Page Page For Your Information Surrounds your child with an extra layer of protection Adds greater strength than car seats with all plastic framesEep your child safer Selecting a Vehicle Seating Location For Your Car Seat Always use vehicle seats That face the front of the vehicle Use vehicle seats That face the side VehicleWhat Kind of Vehicle Belt System Do You Have? These Vehicle Belt Systems You will not be able to keep the car seat secureOnly USE Lap belt is tightened by pulling on its free endRear-Facing Position Rear-Facing Position Birth to 1 Year 6 -30 lbs Harness Adjustment StrapPath Opening Rear-Facing Make sure both shoulder straps are inserted into the buckle Setup Point HarnessFront of the car seat Setup Point Harness Shoulder strap slots Position only if your child’s shoulders are at Pull the connector bar up on the back of the car seat Close the connector bar cover. REAR-FACING Setup Seat Position ReclineBottom of the car seat B Installing Your Car Seat in a Vehicle Never install and restrain a childSee inset will help keep it clean Car seat Buckle the vehicle belt Begins to rise 5B For a manual lap belt system Correct Installing Your Car Seat in a Vehicle Installing Your Car Seat in a Vehicle Correct Incorrect Restraining Your Child Position the crotch strap between your Child’s legs Insert each of the shoulder straps intoRestraining Your Child Restraining Your Child To remove your child from the car seat Insert both shoulder straps into the buckleForward-Facing Position Strap Slots Tether Strap Forward-FacingBelt Path HarnessTether Anchor Installation Tether Anchor Tether StrapTether Anchor Tether Strap Tether Anchor Installation Appropriate eye protection when drilling CarHave to drill a 5/16 hole. Be sure to wear Line of the Safe Embrace ConvertibleStill accessible by the tether strap If a pre-drilled hole does not exist, you willNo more than 4 from the center line Safe Embrace Convertible Car SeatTether Anchor Installation Pick-Up Truck Setup Point Harness Setup Point Harness Tongue face each other. Fasten the chest clip Setup Point Harness Close the connector bar cover Pull the seat position adjuster Setup Seat-Position UprightYou B Installing Your Car Seat in a Vehicle Opposite side of the car seat Front of VehicleBuckle the vehicle belt 4A For a lap and shoulder belt system 4B For a manual lap belt system Installing Your Car Seat in a Vehicle To Remove Correct Metal and plastic parts of the car seat Straps are not twisted Restraining Your Child Buckle the chest clip Restraining Your Child Restraining Your Child Unbuckle the chest clip Consumer Information Aircraft Use Register Your Safe Embrace Convertible Car Seat Seat pad Cleaning and WashingNot use bleach Cleaning and Washing Page Safe Check