Fisher-Price 79701 owner manual Cleaning and Washing, Seat pad, Not use bleach

Page 69

Cleaning and Washing

1From the front of the car seat, lift the harness release lever and pull the shoulder straps out as

far as you can.

2From the back of the car seat, open the connector bar cover.

3 Pull the connector bar out and up.

4 Remove each shoulder strap from each end of the connector bar.

5 From the front of the car seat, pull the shoulder straps out to remove them.

6 Lift the edges of the car seat pad from the car seat shell. Feed the crotch and lap belts through the slots in the car seat pad. Remove the car

seat pad.

7Machine wash the car seat pad in cold water and mild detergent and tumble dry on low heat. Do

not use bleach.

68

Image 69

Contents Safe Embrace Table of Contents Message to Parents Page Page Page For Your Information Adds greater strength than car seats with all plastic frames Surrounds your child with an extra layer of protectionEep your child safer Selecting a Vehicle Seating Location For Your Car Seat Use vehicle seats That face the side Vehicle Always use vehicle seats That face the front of the vehicleWhat Kind of Vehicle Belt System Do You Have? You will not be able to keep the car seat secure These Vehicle Belt SystemsLap belt is tightened by pulling on its free end Only USERear-Facing Position Harness Adjustment Strap Rear-Facing Position Birth to 1 Year 6 -30 lbsPath Opening Rear-Facing Setup Point Harness Make sure both shoulder straps are inserted into the buckleFront of the car seat Setup Point Harness Shoulder strap slots Position only if your child’s shoulders are at Pull the connector bar up on the back of the car seat Setup Seat Position Recline Close the connector bar cover. REAR-FACINGBottom of the car seat B Never install and restrain a child Installing Your Car Seat in a VehicleSee inset will help keep it clean Car seat Buckle the vehicle belt Begins to rise 5B For a manual lap belt system Correct Installing Your Car Seat in a Vehicle Installing Your Car Seat in a Vehicle Correct Incorrect Restraining Your Child Insert each of the shoulder straps into Position the crotch strap between your Child’s legsRestraining Your Child Restraining Your Child Insert both shoulder straps into the buckle To remove your child from the car seatForward-Facing Position Forward-Facing Strap Slots Tether StrapBelt Path HarnessTether Anchor Tether Strap Tether Anchor InstallationTether Anchor Tether Strap Tether Anchor Installation Car Appropriate eye protection when drillingHave to drill a 5/16 hole. Be sure to wear Line of the Safe Embrace ConvertibleIf a pre-drilled hole does not exist, you will Still accessible by the tether strapNo more than 4 from the center line Safe Embrace Convertible Car SeatTether Anchor Installation Pick-Up Truck Setup Point Harness Setup Point Harness Tongue face each other. Fasten the chest clip Setup Point Harness Close the connector bar cover Setup Seat-Position Upright Pull the seat position adjusterYou B Installing Your Car Seat in a Vehicle Front of Vehicle Opposite side of the car seatBuckle the vehicle belt 4A For a lap and shoulder belt system 4B For a manual lap belt system Installing Your Car Seat in a Vehicle To Remove Correct Metal and plastic parts of the car seat Straps are not twisted Restraining Your Child Buckle the chest clip Restraining Your Child Restraining Your Child Unbuckle the chest clip Consumer Information Aircraft Use Register Your Safe Embrace Convertible Car Seat Cleaning and Washing Seat padNot use bleach Cleaning and Washing Page Safe Check