Fisher-Price 79701 owner manual Restraining Your Child, Point harness

Page 32

REAR-FACING POSITION BIRTH TO 1 YEAR (6 - 30 LBS.)

Restraining Your Child

1

2

1Lift the harness release lever and pull the shoulder straps out to loosen the

5-point harness.

2Press the button on the buckle and remove the shoulder straps from the buckle.

HINT	The metal and plastic parts of the car seat

may become very hot when exposed to the sun. When not in use, cover the car seat with a blanket if it will be exposed to the sun for prolonged periods of time.

Before placing your child in the car seat, remove the blanket and check to be sure the metal and plastic parts are not too hot.

31

Image 32

Contents Safe Embrace Table of Contents Message to Parents Page Page Page For Your Information Surrounds your child with an extra layer of protection Adds greater strength than car seats with all plastic framesEep your child safer Selecting a Vehicle Seating Location For Your Car Seat Always use vehicle seats That face the front of the vehicle Use vehicle seats That face the side VehicleWhat Kind of Vehicle Belt System Do You Have? These Vehicle Belt Systems You will not be able to keep the car seat secureOnly USE Lap belt is tightened by pulling on its free endRear-Facing Position Path Opening Rear-Facing Harness Adjustment StrapRear-Facing Position Birth to 1 Year 6 -30 lbs Front of the car seat Setup Point HarnessMake sure both shoulder straps are inserted into the buckle Setup Point Harness Shoulder strap slots Position only if your child’s shoulders are at Pull the connector bar up on the back of the car seat Bottom of the car seat B Setup Seat Position ReclineClose the connector bar cover. REAR-FACING Installing Your Car Seat in a Vehicle Never install and restrain a childSee inset will help keep it clean Car seat Buckle the vehicle belt Begins to rise 5B For a manual lap belt system Correct Installing Your Car Seat in a Vehicle Installing Your Car Seat in a Vehicle Correct Incorrect Restraining Your Child Position the crotch strap between your Child’s legs Insert each of the shoulder straps intoRestraining Your Child Restraining Your Child To remove your child from the car seat Insert both shoulder straps into the buckleForward-Facing Position Strap Slots Tether Strap Forward-FacingBelt Path HarnessTether Anchor Installation Tether Anchor Tether StrapTether Anchor Tether Strap Tether Anchor Installation Appropriate eye protection when drilling CarHave to drill a 5/16 hole. Be sure to wear Line of the Safe Embrace ConvertibleStill accessible by the tether strap If a pre-drilled hole does not exist, you willNo more than 4 from the center line Safe Embrace Convertible Car SeatTether Anchor Installation Pick-Up Truck Setup Point Harness Setup Point Harness Tongue face each other. Fasten the chest clip Setup Point Harness Close the connector bar cover You B Setup Seat-Position UprightPull the seat position adjuster Installing Your Car Seat in a Vehicle Opposite side of the car seat Front of VehicleBuckle the vehicle belt 4A For a lap and shoulder belt system 4B For a manual lap belt system Installing Your Car Seat in a Vehicle To Remove Correct Metal and plastic parts of the car seat Straps are not twisted Restraining Your Child Buckle the chest clip Restraining Your Child Restraining Your Child Unbuckle the chest clip Consumer Information Aircraft Use Register Your Safe Embrace Convertible Car Seat Not use bleach Cleaning and WashingSeat pad Cleaning and Washing Page Safe Check