Fisher-Price 79701 Setup Seat Position Recline, Close the connector bar cover. REAR-FACING

Page 22

REAR-FACING POSITION BIRTH TO 1 YEAR (6 - 30 LBS.)

Setup

Seat Position – Recline

14

11

A

B

12

13

11 Close the connector bar cover. REAR-FACING

RECLINE

		HINT
		HINT	It is easier to close the connector bar cover if
			It is easier to close the connector bar cover if
		you pull the shoulder straps out as far as you can
		on the front of the car seat.

12Pull the seat position adjuster down A . Rotate the seat position adjuster toward the

bottom of the car seat B .

13Make sure the seat position adjuster is flat against the bottom of the car seat.

14DO NOT use the tether strap to install the car seat rear-facing. Store the tether strap by

folding it and fastening it to the back of the car seat. Store the tether anchor and hard- ware in a safe place until you’re ready to use this car seat in the forward-facing posi- tion with a child 1 year and up (22-40 lbs.).

HINT	If the chest clip is not used, store it (buckled

together) with this manual in the pocket on the
side of the car seat.

21

Image 22

Contents Safe Embrace Table of Contents Message to Parents Page Page Page For Your Information Surrounds your child with an extra layer of protection Adds greater strength than car seats with all plastic framesEep your child safer Selecting a Vehicle Seating Location For Your Car Seat Always use vehicle seats That face the front of the vehicle Use vehicle seats That face the side VehicleWhat Kind of Vehicle Belt System Do You Have? These Vehicle Belt Systems You will not be able to keep the car seat secureOnly USE Lap belt is tightened by pulling on its free endRear-Facing Position Rear-Facing Position Birth to 1 Year 6 -30 lbs Harness Adjustment StrapPath Opening Rear-Facing Make sure both shoulder straps are inserted into the buckle Setup Point HarnessFront of the car seat Setup Point Harness Shoulder strap slots Position only if your child’s shoulders are at Pull the connector bar up on the back of the car seat Close the connector bar cover. REAR-FACING Setup Seat Position ReclineBottom of the car seat B Installing Your Car Seat in a Vehicle Never install and restrain a childSee inset will help keep it clean Car seat Buckle the vehicle belt Begins to rise 5B For a manual lap belt system Correct Installing Your Car Seat in a Vehicle Installing Your Car Seat in a Vehicle Correct Incorrect Restraining Your Child Position the crotch strap between your Child’s legs Insert each of the shoulder straps intoRestraining Your Child Restraining Your Child To remove your child from the car seat Insert both shoulder straps into the buckleForward-Facing Position Belt Path Strap Slots Tether StrapForward-Facing HarnessTether Anchor Installation Tether Anchor Tether StrapTether Anchor Tether Strap Tether Anchor Installation Have to drill a 5/16 hole. Be sure to wear Appropriate eye protection when drillingCar Line of the Safe Embrace ConvertibleNo more than 4 from the center line Still accessible by the tether strapIf a pre-drilled hole does not exist, you will Safe Embrace Convertible Car SeatTether Anchor Installation Pick-Up Truck Setup Point Harness Setup Point Harness Tongue face each other. Fasten the chest clip Setup Point Harness Close the connector bar cover Pull the seat position adjuster Setup Seat-Position UprightYou B Installing Your Car Seat in a Vehicle Opposite side of the car seat Front of VehicleBuckle the vehicle belt 4A For a lap and shoulder belt system 4B For a manual lap belt system Installing Your Car Seat in a Vehicle To Remove Correct Metal and plastic parts of the car seat Straps are not twisted Restraining Your Child Buckle the chest clip Restraining Your Child Restraining Your Child Unbuckle the chest clip Consumer Information Aircraft Use Register Your Safe Embrace Convertible Car Seat Seat pad Cleaning and WashingNot use bleach Cleaning and Washing Page Safe Check