SLR • SLC • SLD OPERATOR INSTALLATION GUIDE
GATE OPERATOR
CLASSIFICATIONS
All gate operators can be divided into one of four different classifications, depending on their design and usage.
Class I: Residential
A vehicular gate operator (or system) intended for use in a home of one to four
Class II: Commercial or General Public Access
A vehicular gate operator (or system) intended for use in a commercial location or building such as a
Class III: Industrial or Limited Access
A vehicular gate operator (or system) intended for use in an industrial location or building such as a factory or loading dock area or other locations not intended to service the gen- eral public.
Class IV: Restricted Access
A vehicular gate operator (or system) intended for use in a guarded industrial location or building such as an airport security area or other restricted access locations not ser- vicing the general public, in which unauthorized access is prevented via supervision by security personnel.
IMPORTANT!!
Before installing the gate operator, make sure the gate slides free and level throughout the entire opening distance. If the gate does not seem to operate properly, it may affect the op- erator performance or greatly shorten the life of the unit. The gate should be designed so that airflow through the fabric is ample to prevent wind resistance and drag.
SAFETY INFORMATION
AND WARNINGS
Read the following before beginning to install OSCO slide gate operators:
1.Read the yellow “Safety Instructions” brochure enclosed with the packet of information. If you do not have one, please call OSCO at
2.All electrical connections to the power supply must be made by a licensed electrician and must observe all national and local electrical codes.
3.A separate
4.Install the enclosed warning signs on both sides of the gate. Each sign must be plainly visible from the side of the gate on which they are mounted.
5.Never reach between, through or around the fence to operate the gate.
6.You must install all required safety equipment.
PRE-INSTALLATION INFORMATION
Before unpacking, inspect the carton for exterior damage. If you find damage, advise the delivery carrier of a potential claim.
Inspect your package carefully. For your convenience, you can check your accessory box parts with the enclosed pack- ing slip. Claims for shortages will be honored for only 30 days from the date of shipment.
Before installing the operator, read this manual completely to ensure all requirements for proper installation are present. Verify that the voltage to be used matches the voltage of the operator.
The following contact or
Contact Edges:
Miller Models*:
Photoeyes:
*for OSCO part numbers, contact a sales representative for details
- 3 - |