Gate Operator Installation Checklist

SLR • SLC • SLD OPERATOR INSTALLATION GUIDE

INSTALLER	CUSTOMER
________	________	1.	The gate has been checked to make sure it is level and moves freely in both directions.
________	________	2.	Potential pinch areas have been guarded so as to be inaccessible OR have contact and/or
			non-contact obstruction sensing devices installed.
________	________	3.	The installer has installed one or more contact or non-contact obstruction sensing devices, in
			compliance with UL325 requirements for this installation.
________	________	4.	The slide gate has been screened or secured from the bottom of the gate to a minimum of 48
			inches above ground to prevent a 2 1/4-inch sphere from passing through the openings any-
			where in the gate and in that portion of the adjacent fence that the gate covers when the gate
			is in the open and closed positions. Picket gates which have spacings less than 2 1/4 inches
			apart to the minimum height requirement are also acceptable.

________ ________

5.Roller covers have been installed on cantilever gates.

6.If pedestrian traffic is expected, a separate pedestrian gate has been installed, a minimum of seven feet from the gate. The customer has been informed that all pedestrian traffic must use the pedestrian gate.

________ ________	7. Warning signs have been installed on each side of the gate in highly visible locations. The
	customer has been informed that these signs must remain at all times.

________ ________

8.There are no controls installed on the gate operator, or within seven feet of the gate.

9.The installer has properly adjusted the obstruction sensing feature and has tested the gate to make sure that the gate stops and reverses a short distance with minimal resistance applied (40 lbs. on a swing gate at the end of the gate, 75 lbs. on a slide gate)

________	________	10.	The installer has instructed the customer in the proper use of the gate operator and reviewed
			all of the operational functions, obstruction sensing devices, warning beeper and reset, etc.
________	________	11.	The installer has instructed the customer in the proper use of the operator’s manual discon-
			nect feature. The manual disconnect must never be used while the gate is in motion. The
			power switch must be turned off before using the manual disconnect and disengaging the
			operator.
________	________	12.	The installer has reviewed all safety instructions with the customer, and has left the safety
			instructions and owner’s information sheets for their reference.

________ ________

13.The installer has answered any questions the customer has regarding the operation of the gate operator and gate operator safety precautions.

14.The installer has explained to the customer that a regular maintenance schedule for both the gate and the gate operator is recommended.

By signing this installation checklist, I/we hereby certify that each item listed and checked above has been covered by the installer and is clearly understood by the customer.

______________________________________________	_____________________________
Customer Signature	Date
______________________________________________	_____________________________
Installer Signature	Date

- 40 -