Bushnell 119415, 119405 instruction manual Mounting the Bushnell Trophy CAM, Factory Default

4.9 Factory Default

When leaving the factory, most commonly used parameters usually have their default for the product. These values are all optimal or commonly used. The predetermined values of primary parameters for the BUSHNELL TROPHY CAM are shown in table 1 of 3.7.

5 Mounting the BUSHNELL TROPHY CAM

When you want to use the ON mode of the BUSHNELL TROPHY CAM in the outdoors, for scouting, you must mount the device in a certain place properly. It is recommended to mount the BUSHNELL TROPHY CAM on a tree whose diameter is about 6 in. (15cm). To get the optimal picture quality, the tree can be 16-17 ft. (5 meters) away from the place to be monitored, and at a height of 5-6.5 ft. (1.5~2 m).

There are two ways to mount the BUSHNELL TROPHY CAM : using a band shaped strap, or the bottom screw.

Using the strap: To use the strap to fix the BUSHNELL TROPHY CAM on a tree is illustrated in Fig. 17. Take the strap ends and go through the two back holes of the BUSHNELL TROPHY CAM At the end, tie the buckle the strap together around the tree.

Using Bottom screw: The camera is equipped with a socket at the bottom to enable mounting on a tripod or other mounting accessories with 1/4- 20 thread.

Figure 17: Using the Strap for Mounting

31