JAI CV-M300 operation manual

Page 14

CV-M300

Cautions in the Long Time Exposure Mode.

1.Theoretical exposure time is as follows. EIA: 1/30 sec. to . CCIR: 1/25 sec. to .

2.It is recommended not to use exposure >2 sec. since visible dark-current noise may occur.

3.Ext. HD signal (4.0 Vp-p ± 2.0V at 75 Ohm terminated) has to be input continuously The falling edge of Ext. HD signal and Ext. VD signal are phase-synchronized.

4.Timing of ext. VD signal in each accumulation mode has to be set, as described before.

a)2:1 Interlaced mode (Field accumulation mode)

b) 2:1 Interlaced mode (Frame accumulation mode)

c) Non interlaced mode (Field accumulation mode)

- 13 -

Image 14
Contents CV-M300 Declaration of Conformity Table of Contents Standard Composition Main Features GeneralLocations and Functions Pin Assignment Pin Multi-connector DC-IN/SYNCPin Multi-connector Trigger External Trigger Mode Input/Output of HD/VD SignalNormal Shutter Mode Functions and OperationsEIA Non-interlaced / Field accumulation mode =4.4∝ SCcir Non-interlaced / Field accumulation mode Pulse Width Control ModePulse width control mode for non-interlace only Start/Stop Trigger Mode CV-M300 Long Time Exposure Mode EIA CcirCV-M300 Table for SW 1 Setting Mode Setting1. SW1 Switch on the Rear Panel OFF = On =SW2 on PK8041 Board Jumper Settings Pixel Clock OutputJP10JP12 Adjustment of Video Signal Output Level External Appearance Tripod mount plateSpecifications Spectral SensitivityAppendix PrecautionsTypical CCD Characteristics Camera type CV-M300 Scanning system Users Mode Settings Users ModificationsUser’s Record Revision Revision E Serial No2700-11088E E1