JAI CV-M300 operation manual Locations and Functions

Page 5

CV-M300

4. Locations and Functions

12/3" interline transfer CCD sensor.

2Lens mount of C-mount type. *1)

3BNC connector for video output.

4Switch block SW1 for shutter speed and function modes setting.

56-pin multi connector for WEN and EEN output external trigger input.

612-pin multi connector for +12V DC power, video output and HD/VD input/output.

7GAIN potentiometer for manual gain adjustment.

8Screw holes for Tripod mount plate.

9Tripod mount plate to place the camera on tripod.

Note: *1) Rear protrusion on C-mount lens must be less than 10.0 mm (0.4 inches approx.). When IR-cut filter is used, it must be less than 7.0 mm (0.28 inches approx.).

The IR cut filter is placed in the C-mount thread.

The C-mount 25 mm IR cut filter must be ordered separately.

- 4 -

Image 5

Contents CV-M300 Declaration of Conformity Table of Contents General Standard Composition Main FeaturesLocations and Functions Pin Assignment Pin Multi-connector DC-IN/SYNCPin Multi-connector Trigger Normal Shutter Mode Input/Output of HD/VD SignalExternal Trigger Mode Functions and Operations=4.4∝ S EIA Non-interlaced / Field accumulation modePulse Width Control Mode Ccir Non-interlaced / Field accumulation modePulse width control mode for non-interlace only Start/Stop Trigger Mode CV-M300 EIA Ccir Long Time Exposure ModeCV-M300 1. SW1 Switch on the Rear Panel Mode SettingTable for SW 1 Setting OFF = On =SW2 on PK8041 Board Pixel Clock Output Jumper SettingsJP10JP12 Adjustment of Video Signal Output Level Tripod mount plate External AppearanceSpectral Sensitivity SpecificationsAppendix PrecautionsTypical CCD Characteristics User’s Record Users Mode Settings Users ModificationsCamera type CV-M300 Scanning system Revision Revision E Serial No2700-11088E E1