JAI CV-M300 operation manual JP10JP12

Page 18

7.4.2. Board PK8042 Side A

7.4.1. Board PK8041 Side A

CV-M300

7.4. Location of SW2 and JumpersJP8JP9SW2JP7

Jumpers are shorted with a 0 Ohm resistor or by a soldering between the 2 points. To remove the solder tin from a jumper position, use a special tin remover such as de-soldering wick.

JP10JP12

JP14

- 17 -

Image 18

Contents CV-M300 Declaration of Conformity Table of Contents Standard Composition Main Features GeneralLocations and Functions Pin Multi-connector DC-IN/SYNC Pin Multi-connector TriggerPin Assignment External Trigger Mode Input/Output of HD/VD SignalNormal Shutter Mode Functions and OperationsEIA Non-interlaced / Field accumulation mode =4.4∝ SCcir Non-interlaced / Field accumulation mode Pulse Width Control ModePulse width control mode for non-interlace only Start/Stop Trigger Mode CV-M300 Long Time Exposure Mode EIA CcirCV-M300 Table for SW 1 Setting Mode Setting1. SW1 Switch on the Rear Panel OFF = On =SW2 on PK8041 Board Jumper Settings Pixel Clock OutputJP10JP12 Adjustment of Video Signal Output Level External Appearance Tripod mount plateSpecifications Spectral SensitivityPrecautions Typical CCD CharacteristicsAppendix Camera type CV-M300 Scanning system Users Mode Settings Users ModificationsUser’s Record Revision Revision E Serial No2700-11088E E1