JAI CV-M300 Pin Assignment, Pin Multi-connector DC-IN/SYNC, Pin Multi-connector Trigger

Page 6

CV-M300

5. Pin Assignment

5.1.12-pin Multi-connector (DC-IN/SYNC.)

Type: HR10A-10R-12PB-01 (Hirose) male Seen from rear.

Pin1no.	Signal				Remarks
5	GND	ParallelwiththeBNCvideooutput.Avoiddoubletermination.
423	+12VideoDCinput	ParallelwiththeBNCvideooutput.Avoiddoubletermination.
67	HDVinput/output	HDV	inasfactorysetting.*1)		*2)
8	+12VGNDNCDCinput	NCasfactorysetting.Pixelclockoutput.*1)
1290	+12VGNDNCDCinput	NCasfactorysetting.Pixelclockoutput.*1)
Notes:
*1) Signals on pin no. 6, 7 and 9 can be changed by jumper setting.						Remarks
Seen from rear.	Pin1no.			SignalNC		Remarks
See “7.3. Jumper Settings” for more information.
*2) In Edge Pre-select and Pulse Width Control mode do not input ext. VD signal.
	64235			ExtWENEEN.TrigGNDNCoutputoutputinput	NoteNote
5.2. 6-pin Multi-connector (TRIGGER)

Type: HR10A-7R-6PB (Hirose) male

* Notes:

The functions available on the 6-pin multi-connector are not effective in long time exposure mode.

- 5 -

Image 6

Contents CV-M300 Declaration of Conformity Table of Contents Standard Composition Main Features GeneralLocations and Functions Pin Multi-connector DC-IN/SYNC Pin Multi-connector TriggerPin Assignment External Trigger Mode Input/Output of HD/VD SignalNormal Shutter Mode Functions and OperationsEIA Non-interlaced / Field accumulation mode =4.4∝ SCcir Non-interlaced / Field accumulation mode Pulse Width Control ModePulse width control mode for non-interlace only Start/Stop Trigger Mode CV-M300 Long Time Exposure Mode EIA CcirCV-M300 Table for SW 1 Setting Mode Setting1. SW1 Switch on the Rear Panel OFF = On =SW2 on PK8041 Board Jumper Settings Pixel Clock OutputJP10JP12 Adjustment of Video Signal Output Level External Appearance Tripod mount plateSpecifications Spectral SensitivityPrecautions Typical CCD CharacteristicsAppendix Camera type CV-M300 Scanning system Users Mode Settings Users ModificationsUser’s Record Revision Revision E Serial No2700-11088E E1