Hach 6120118 user manual FCC Part 15, Class a Limits, Compliance Information

Page 44

Compliance Information

Canadian Interference-causing Equipment Regulation, IECS-003, Class A

Supporting test records by Hewlett Packard, Fort Collins, Colorado Hardware Test Center (A2LA # 0905-01) and certified compliance by Hach Company.

This Class A digital apparatus meets all requirements of the Canadian Interference- Causing Equipment Regulations.

Cet appareil numèrique de la classe A respecte toutes les exigences du Rëglement sur le matÈriel brouilleur du Canada.

FCC PART 15, Class “A” Limits

Supporting test records by Hewlett Packard, Fort Collins, Colorado Hardware Test Center (A2LA # 0905-01) and certified compliance by Hach Company.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1)this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case the user will be required to correct the interference at his own expense. The following techniques of reducing the interference problems are applied easily.

1.Disconnect the Controller from its power source to verify that it is or is not the source of the interference.

2.If the Controller is connected into the same outlet as the device with which it is interfering, try another outlet.

3.Move the Controller away from the device receiving the interference.

4.Reposition the receiving antenna for the device receiving the interference.

5.Try combinations of the above.

44

Page 43 Page 45
Image 44
Page 43 Page 45
Contents Digital PC sc and RC sc ¾-inch Combination pH/ORP Sensor Page Table of Contents Table of Contents Digital Gateway Specifications SpecificationsCombination pH and ORP Sensor Specifications Page Safety Information Precautionary LabelsGeneral Information Use of Hazard InformationSensor Body Styles General Sensor InformationGeneral Information Operating Precaution Digital GatewayPage Section Installation Wiring the sc Sensor to the Digital GatewayInstallation Proper Wire Preparation and InsertionWiring the Digital Gateway Cat. No Hard-wiring the Digital Gateway to the sc100 Wiring the Sensor at Terminal Block J5 Terminal Number Terminal Designation Wire ColorConnecting the Sensor to the sc1000 Connecting the Sensor using the Quick-connect FittingsDigital Gateway Dimensions Mounting the Digital GatewayPage Using the sc100 Controller Controller Key Functions/FeaturesUser Interface and Navigation Number Key FunctionDisplay User Interface and Navigation Controller Display FeaturesImportant Key Presses User Interface and Navigation Using the sc1000 ControllerDisplay Features Navigating the Menu Windows Main MenuKeypad List Box Message windowSensor Setup Sensor Diagnostics Menu for pH and ORPPH Sensor Setup Menu OperationConfigure OperationORP Sensor Setup Menu AC FrequencyTwo Point Automatic Calibration PH CalibrationOne Point Automatic Calibration Operation One Point Manual Calibration Two Point Manual CalibrationOne-point Manual Calibration ORP CalibrationConcurrent Calibration of Two Sensors for pH and ORP Adjusting the Temperature Page Maintenance Maintenance ScheduleCleaning the Sensor MaintenanceTroubleshooting Error CodesTroubleshooting the pH or ORP Sensor Error CodesPage Replacement Parts and Accessories Replacement Items, Accessories, and Reagent and StandardsItem Description Catalog NumberPage How to Order Technical and Customer Service U.S.A. onlyA. Customers Information RequiredRepair Service CanadaLimitation of Remedies Limited WarrantyLimitations Page Product Safety Compliance InformationImmunity EmissionsFCC Part 15, Class a Limits Compliance InformationGroup Name Tag Name Register Data Length Description Type Appendix a Modbus Register InformationSensor Modbus Registers Modbus Register Information Where Appendix B General pH InformationPH Measurement Theory PID Controller Basics General pH InformationIntegral DerivativePage Index
Top Page Image Contents