Nikon MRDI user manual Summary of CAM/CMOS-2K.LS Modes Line Start End

ExSync Line Synchronization with Electronic Shutter Control is the fourth mode (Figure 3.4.5). It gives the user asynchronous hardware control both start and end of integration.

The control lines ExSync and ElectronicShutter are CameraLinkTM lines CC1 and CC2 respectively as described in Reference A, and must be asserted by the frame grabber.

Table 3.4.1

Summary of CAM/CMOS-2K.LS Modes

	Mode		Line	Line	Start	End
		Synchronization	Start		of	of
				End
			Trigger		Integration	Integration
			The	Line Ends
			CAM/CMOS -		tInitiation
		The CAM/CMOS		tLinePeriod - tXFR		tIntegration
			2K.LS
		2K.LS drives the frame	LineValid	after	+ tReset
	Free	grabber(s).	Camera	LineValid	-tXFR	after
1	Running		Output	Camera Output		start of Integration
		Motion of the subject	Triggers
				Goes High	after
	(factory default)	being imaged must be	the			User may set
		synchronized to the	frame		LineValid
		CAM/CMOS-2K.LS	grabber(s)	User may set	Camera Output	tIntegration
		.	by	tLinePeriod	Goes High	with Software
			Going
				with Software
			High
	ExSynch			When the User	tReset	When the User
2				takes	after	takes
	Sychronization					ExSynch
			The	ExSynch	the System
				Camera Input Low		Camera Input Low
			User		takes
	ExSynch			Again
			Triggers		the	tIntegration + tReset
	Synchronization	The User	the
					ExSynch	after User
3	with	Synchronizes	CAM/CMOS-	(In this way,
		the	2K.LS		Camera Input	takes ExSync
	Programmable			the
		CAM/CMOS-2K.LS	by		High	Camera Input High
	Integration Time			Line Rate
		via an	taking
	ExSynch	Encoder.	ExSynch	is	tReset	When
			Camera	User-Set
	Synchronization				after
			Input	by		the User
	with				the User
4			Low	Frequency		takes the
	Electronic				takes
				of		ElecShutter
	Shutter				ElectronicShutter
				ExSynch)		Camera Input Low
	Control				Camera Input High

Fairchild Imaging • CAM/CMOS-2K.LS Line Scan Camera User’s Manual • Rev A • 19 of 41