Yamaha RX-V363 owner manual Additional operations, 30 En

Playback

Additional operations

■Using your headphones

Connect a pair of headphones with a stereo analog audio cable plug to the PHONES jack on the front panel.

VOLUME

STANDBY

/ON

EDIT
PRESET/TUNING	BAND	A/B/C/D/E	l	PRESET/TUNING	h	MEMORY	TUNING AUTO/MAN'L

SCENE

1 2 3 4

		l PROGRAM h		l	INPUT h		VIDEO AUX
PHONES	SPEAKERS	TONE CONTROL	STRAIGHT	NIGHT	AUDIO SELECT	VIDEO	L AUDIO R	PORTABLE
	A/B/OFF
SILENT CINEMA			EFFECT

y

When you select a sound field program, SILENT CINEMA mode is automatically activated (see page 36).

Notes

•When you connect headphones, no signals are output at the speaker terminals.

•All Dolby Digital and DTS audio signals are mixed down to the left and right headphone channels.

■Muting the audio output

Press FMUTE to mute the audio output.

Press FMUTE again to resume the audio output.

y

•You can also rotate H VOLUME (or press IVOLUME +/–) to resume the audio output.

•You can adjust the muting level by using “MUTE TYP.” in “SOUND MENU” (see page 48).

•The MUTE indicator flashes in the front panel display when the audio output is muted and disappears from the front panel display when the audio output is resumed.

■Selecting the front speaker set

Press I SPEAKERS repeatedly to turn on or off the set of front speakers connected to the FRONT A or FRONT B speaker terminals.

The active front speaker set changes as follows:

FRONT A FRONT B

OFF

Note

Turn off the volume level of this unit when you switch the front speaker setting.

■Using the Zone B feature

When you set “FRONT B” to “ZONE B” (see page 45), you can use the speakers connected to the FRONT B speaker terminals in another room (Zone B).

Press I SPEAKERS on the front panel repeatedly to turn on or off the Zone B speakers.

When you activate the Zone B speakers, all the speakers in the main room are muted.

Notes

•You cannot activate both the main room and Zone B speakers simultaneously.

•If you select CINEMA DSP sound field program and activate the Zone B speakers, Virtual CINEMA DSP activates automatically (see page 36).

■Selecting the component connected to the MULTI CH INPUT jacks as the input

source

Use this feature to select the component connected to the MULTI CH INPUT jacks (see page 17) as the input source.

Press N INPUT l/ h repeatedly (or press

4AMP and then press BMULTI CH IN) so that “MULTI CH” appears in the front panel display.

y

Use “MULTI CH SET” menu in “INPUT MENU” to set the parameter for MULTI CH INPUT (see page 49).

Notes

•The input signals are amplified and output directly without sound processing. Therefore, you cannot activate sound field programs, the night listening mode, etc. while MULTI CH is selected as the input source.

•When headphones are used, signals are output only from the front left and right channels.

30 En