■Selecting audio input jacks
(AUDIO SELECT)
This unit comes with a variety of input jacks. Use this feature (audio input jack select) to switch the input jack assigned to an input source when more than one jacks are assigned to an input source.
y
•We recommend setting audio input jack select to “AUTO” in most cases.
•You can adjust the default audio input jack select of this unit by using “AUDIO SELECT” in “OPTION MENU” (see page 50).
Press O AUDIO SELECT (or press 4AMP and then CAUDIO SEL) repeatedly to select the
desired Audio input jack select setting.
DVR
| Audio input jack select setting | |
AUTO | Automatically selects input signals in the | |
| following order: | |
| (1) | Digital signals |
| (2) | Analog signals |
ANALOG | Selects only analog signals. If no analog | |
| signals are input, no sound is output. |
Note
This feature is not available when no digital input jack are assigned to the currently selected input source.
■Selecting the night listening mode
The night listening modes are designed to improve listenability at lower volumes or at night.
1Press 4AMP and then press MNIGHT repeatedly to select “NIGHT:CINEMA” or “NIGHT:MUSIC”.
Choices: NIGHT:CINEMA, NIGHT:MUSIC, NIGHT OFF
•Select “NIGHT:CINEMA” to reduce the dynamic range of film soundtracks and make dialog easier to hear at lower volumes.
•Select “NIGHT:MUSIC” to preserve
•Select “NIGHT OFF” if you do not want to use this feature.
y
When a night listening mode is selected, the NIGHT indicator lights up in the front panel display.
Playback
2Press 7l/ hto adjust the effect level while “NIGHT:CINEMA” or “NIGHT:MUSIC” is displayed in the front panel display.
Choices: MIN, MID, MAX
•Select “MIN” for minimum compression.
•Select “MID” for standard compression.
•Select “MAX” for maximum compression.
y
“NIGHT:CINEMA” and “NIGHT:MUSIC” adjustments are stored independently.
Notes
•You cannot use the night listening modes in the following cases:
–when the component connected to the MULTI CH INPUT jacks is selected as the input source.
–when headphones are connected to the PHONES jack.
–when the sampling frequency of the input sources are higher than 96 kHz.
•The night listening modes may vary in effectiveness depending on the input source and surround sound settings you use.
■Adjusting the tonal quality
Use this feature to adjust the balance of bass and treble for the front left and right speaker channels.
Press J TONE CONTROL repeatedly to select “BASS” or “TREBLE” and then press
KPROGRAM l/ hto adjust the corresponding frequency response level.
Control range:
Control step: 2
• Select “BASS” to adjust the
• Select “TREBLE” to adjust the
Notes
•Speaker and headphone adjustments are stored independently.
•If you increase or decrease the
OPERATION | BASIC |
|
|
English