Ricoh FV-L200B1 manual 30/32

Command No.								Command Descriptions
A0H:	[Pixel defect correction mode] Initial data: PDC0[7..0] = 0
PDC0[70]	D[7..0]
	D7	D6	D5	D4	D3	D2	D1	D0
	D7:		Write the correction index					0 ￿ 1
			*Writes the coordinates of the command, A2 to A5, to the index number specified by the
			command A1.
			*This bit is cleared to “0” automatically after the execution of the command.
	D6		Read the correction index					0 ￿ 1
			*Reads the coordinates of the index number specified by A1 and loads them to the command,
			A6 to A9.
			*This bit is cleared to “0” automatically after the execution of the command.
	D5:		Save to the EEPROM					0 ￿ 1
			*Writes the coordinates of all 16 index numbers to the EEPROM.
			*This bit is cleared to “0” automatically after the execution of the command.
	D4 to D2		No function					Always set as “000”
	D1		Correction indices display					0: OFF	1: ON
	D0		Pixel defect correction					0: OFF	1: ON
A1H:	[Pixel defect correction index number]Initial data: PDC1[7..0] = 0, data range: 0 to 15
PDC0[70]	D[7..0]
	D7	D6	D5	D4	D3	D2	D1	D0
	D7 to D4:		No function					Always set as “0000”
	D3 to D0:		Index number
A2H:	[PDC X coordinate (Write)]
PDC_WX[70]	Initial data: PDC_WX[15..0] =0, data range: 0 to the number of horizontal pixels of the effective area
A3H	Set the X coordinate of pixel defect.
PDC_WX[158]
A4H:	[PDC Y coordinate (Write)]
PDC_WY[70]	Initial data: PDC_WY[15..0] = 0, data rage: 0 to the number of vertical pixels of the effective area
A5H	Sets the Y coordinate of pixel defect.
PDC_WY[158]
A6H:	[PDC X coordinate (Read)]
PDC_RX[70]	Initial data: PDC_RX[15..0] = 0, data rage: 0 to the number of vertical pixels of the effective area
A7H	The X coordinate of pixel defect will be loaded when reading.
PDC_RX[158]
A8H:	[PDC Y coordinate (Read)]
PDC_RY[70]	Initial data: PDC_RY[15..0] = 0, data rage: 0 to the number of vertical pixels of the effective area
A9H	The Y coordinate of pixel defect will be loaded when reading.
PDC_RY[158]
C0H: [70]	[Lower limit of the electronic shutter] Initial data: 1; data range: 0 to 4,095
C1H: [70]	Sets the upper limit of the electronic shutter in horizontal lines when using AE (auto exposure).
C2H: [70]	[Upper limit of the electronic shutter] Initial data: 4,095; data range: 0 to 4,095
C3H: [70]	Sets the upper limit of the electronic shutter in horizontal lines when using AE (auto exposure).

FVL200B1	30/32
User’s Guide Rev. 1.01