TRENDnet trendnet The Megapixel PoE Dome Internet Camera with IR manual

Page 34

TRENDnet User’s Guide

2.Login to your router’s web configuration page.

3.Find the Dynamic DNS configuration section.

4. Enable DDNS, fill out the following information and then click Apply.

TV-IP262PI

5.Go to Virtual Server* section and create a new entry.

Enable: Click Enable

Name: Enter the application name (eg. Camera Name)

Protocol: Select TCP

Private Port: The HTTP port that you assign on your Camera.

Public Port: The port used on remote side to access to your Camera.

LAN Server: The local IP address of your Camera.

Click Add to add the application.

*Please refer to your router’s user’s manual for detail Virtual Server setting. Some router might use Port Forwarding or Special applications for this function. The setup steps should be very similar.

6.Open another web browser and enter your DDNS domain and camera’s port number.

http://yourDomainName:PortNumber

7.The camera login page will appear.

Image 34

Contents Page Contents Package Contents FeaturesRear Panel View Product Hardware FeaturesFront Panel View ∙ LED indicators Application DiagramInside Component Installation Hardware InstallationCamera Installation Lick the Install CameraTV-IP262PI TV-IP262PI Starting Camera Finder Click StartProgramsTRENDnetIPSetup, and then click IPSetup Configuration Viewing Camera Basic FunctionLive View/Setup Switch Configuring the Camera SettingSelect ToolsInternet Options Select Security ∙ Email Settings ∙ Camera Setting∙ IP Setting Smart WizardBasic ∙ Confirm SettingsBasic System ∙ General User Basic Date & TimeBasic User ∙ Guest∙ Direct Video Stream Authentication NetworkNetwork Network ∙ Ports NumberNetwork Advanced ∙ QoSAccept Video & AudioNetwork IP Filter DenyVideo & Audio Camera ∙ Image SettingNight mode Change night mode to color or Mono Video & Audio VideoVideo & Audio Audio 264Video & Audio Overlay / Mask Event Server Video & Audio Overlay / Mask Text OverlayEvent Server Setting FTP Http Notify For Motion TriggerEvent Server Setting Email Event Server Setting Network Storage ∙ Network StorageMotion Detect Event Server Setting Instant Message∙ Instant Message Event Config Event Configuration General Setting ∙ GeneralEvent Configuration Motion Detect Trigger Event Configuration Schedule TriggerTools SD CardSD Card SD Card Setting SD Card File ManagerInformation Device Info Device InfoInformation System Log How to setup/access the camera behind a Router Configure Ddns on your CameraConfigure Ddns on your router Enable Click EnableProtocol Select TCP Name Enter the application name eg. Camera Name Power Reset ButtonPower Consumption DimensionRequirement Management Backup / RestoreSettings Image Interface To Run SecurViewCamera can be accessed locally but not remotely Power LED and Ethernet Activity LED do not light upCamera can’t be accessed or access is slow Supports up to 2 destination accountsCamera images are ‘noisy’ White vertical lines appear on the image from the cameraCamera images are blurry Camera images are of poor qualityLimited Warranty TV-IP262PI 3 Years Limited WarrantyLimited Warranty