TRENDnet trendnet The Megapixel PoE Dome Internet Camera with IR manual System Log Entries max

Page 37

TRENDnet User’s Guide

Port Settings	HTTP port: 80 (default)
	RTSP port: 554 (default)
Digital Zoom	3x
Dynamic DNS	Yes
Time	Synchronize with NTP server or set time/date manually
Email	Supports up to 2 destination accounts
System Log	100 entries (max.)

TV-IP262PI

Troubleshooting

1.The Power LED and Ethernet Activity LED do not light up.

The power supply or camera might be faulty. Check that the connection to both the power source and the terminal on the back of the camera are secure and that you are using the provided power supply. If the camera is otherwise functioning correctly, the LEDs might have been disabled in the configuration. See the System section under the Basic menu.

2.The camera can’t be accessed or access is slow

There might be a problem with the network cable. To confirm that the cables are working, ping the address of a known device on the network. If the cabling is OK and your network is reachable, you should receive a reply similar to the following (…bytes = 32 time = 2 ms).

Another possible problem may be that the network device such as a hub or switch utilized by the Network Camera is not functioning properly. Please confirm the power for the devices are well connected and functioning properly.

3.The camera can be accessed locally but not remotely

This might be caused by a firewall. Check the Internet firewall with your system administrator. The firewall may need to have some settings changed in order for the Network Camera to be accessible outside your local LAN. For more information, please refer to the section about setting up/accessing your camera behind a router.

© Copyright 2012 TRENDnet. All Rights Reserved.

36

Image 37

Contents Page Contents Features Package ContentsRear Panel View Product Hardware FeaturesFront Panel View ∙ LED indicators Application DiagramInside Component Hardware Installation InstallationLick the Install Camera Camera InstallationTV-IP262PI TV-IP262PI Starting Camera Finder Click StartProgramsTRENDnetIPSetup, and then click IPSetup Viewing Camera Basic Function ConfigurationLive View/Setup Switch Configuring the Camera SettingSelect ToolsInternet Options Select Security ∙ IP Setting ∙ Camera Setting∙ Email Settings Smart WizardBasic ∙ Confirm SettingsBasic System Basic User Basic Date & Time∙ General User ∙ GuestNetwork ∙ Direct Video Stream Authentication∙ Ports Number Network Network∙ QoS Network AdvancedNetwork IP Filter Video & AudioAccept DenyNight mode Change night mode to color or Mono ∙ Image SettingVideo & Audio Camera Video & Audio VideoVideo & Audio Audio 264Video & Audio Overlay / Mask Video & Audio Overlay / Mask Text Overlay Event ServerHttp Notify For Motion Trigger Event Server Setting FTPEvent Server Setting Network Storage ∙ Network Storage Event Server Setting EmailMotion Detect Event Server Setting Instant Message∙ Instant Message Event Configuration General Setting ∙ General Event ConfigEvent Configuration Schedule Trigger Event Configuration Motion Detect TriggerSD Card ToolsSD Card File Manager SD Card SD Card SettingInformation Device Info Device InfoInformation System Log Configure Ddns on your Camera How to setup/access the camera behind a RouterConfigure Ddns on your router Enable Click EnableProtocol Select TCP Name Enter the application name eg. Camera Name Power Consumption Reset ButtonPower DimensionSettings Image Backup / RestoreRequirement Management Interface To Run SecurViewCamera can’t be accessed or access is slow Power LED and Ethernet Activity LED do not light upCamera can be accessed locally but not remotely Supports up to 2 destination accountsCamera images are blurry White vertical lines appear on the image from the cameraCamera images are ‘noisy’ Camera images are of poor qualityTV-IP262PI 3 Years Limited Warranty Limited WarrantyLimited Warranty