Configuring
3.5Customize the display of the cam
3.Either the window Master Properties (for the master axis) or the window S Diagram Properties (Slave) (for the slave axis) is displayed.
For the master axis, change the representation parameters in the window Master Properties.
Figure 3-11 Master Properties window
For the slave axis, change the representation parameters in the window S Diagram (Slave)
Properties.
Figure |
| ||
Table | Parameters in the Master Properties or S Diagram (Slave) Properties | ||
|
|
|
|
|
| Field/button | Explanation/instructions |
Master Range | You specify the master range (definition range) of the curve | ||
(Master Properties) | via start and end points. Cam segments must lie within this | ||
|
|
| master range (see also Master range under Target device |
|
|
| properties in the Coordinates tab). |
| Start |
| Enter the start point of the curve, or the start of the master |
|
|
| range of the curve here. |
| End |
| Enter the end point of the curve, or the end of the master |
|
|
| range of the curve here. |
CamTool | |
Configuration Manual, 12.2004, |