Siemens 6AU1900-1AB32-0BA0 configurationmanual Slave axis Basic scaling

Functions

4.9 Specify parameters for target device

		Field/button	Explanation/instructions
Slave axis
	Basic scaling		Enter the basic scaling of the slave axis here. The center of the scaling is
			always the coordinate origin.
			Note:
			Do not use any scaling values which are greater than 5. Greater values
			cause a roughness in the curve characteristic.
	Scalings		You can specify the scalings of two ranges of the slave axis here. The
			center of the scaling is the start point of the scaling range.
			Note:
			If you specify two ranges, the ranges cannot overlap.
		(Range1)	Under From and To, enter the range that you want to scale. Under
			Factor, enter the scaling factor.
			Note:
			Do not use any scaling values which are greater than 5. Greater values
			cause a roughness in the curve characteristic.
		(Range2)	Under From and To, enter the range that you want to scale. Under
			Factor, enter the scaling factor.
			Note:
			Do not use any scaling values which are greater than 5. Greater values
			cause a roughness in the curve characteristic.
	Offset		You can enter a factor for the offset of the slave axis here. If you have
			specified a scaling, the offset applies to the scaled curve. If you have not
			specified a scaling, the offset applies to the unscaled curve.

4-34	CamTool
	Configuration Manual, 12.2004, 6AU1900-1AB32-0BA0