Polaroid SX70 manual Fresnel standards chart

Page 45

you to a chart. In all cases, the fault analysis charts present the logical sequence of checks and remedial procedures. These charts are divided into three parts :

-one, (CAMERAANALYSIS) for problem analysis when the camera is completely assembled

-two, (OPTICAL ANALYSIS) for analysis of the viewfinder parts

-three, (SHUTTER ANALYSIS) for detailed shutter analysis.

The SHUTTER ANALYSIS charts should be

used only after the shutter has been unsoldered from the camera. If repairs and/or replacements are indicated, the procedures are described in Section IV.

Figure 3-16 Fresnel standards chart

Image 45
Contents Page Page General Description DescriptionOpening the Camera Camera OperationStarting the Automatic Mechanism Loading the Film packViewing and focusing Setting the exposure counterViewing and shooting Exposures using flash Completing the film packDeveloping the print Closing the camera Shutter Description Ambient Light Mode11 a Location & Arrangement of internal parts Shutter Description Flash Mode Page 14 S5 being opened by the recock ram Gear train Page Introduction Power SourceLens Viewing and Exposing SystemViewfinder optics exposing Fresnel Figures 2-3 a and 2-3 BFresnel screen Mirrors ViewfinderFlare baffle Camera Elctronics 1. GeneralSX-70 Switch locations Switch functionsS3 Being opened by recock ram S4 Switch operating configurations Function Sequence Switch Function TablePage Flash Timing Sequence Chart Shutter, exploded view Shutter Mechanical Details FigureA Solenoid S2 operation Sequence of Operations Film Processing ComponentsPage Max Introduction Initial Tests III TroubleshootingSX-70 Cmaera Repair Inspection Procedure Test Equipment Operation Power supply and pack simulator FigureLocation of new collimator target Collimator FigureDisengaging the idler gear Comprehensive tester Comprehensive Testers -6Model B Camera tester Model B Camera Tester Light Leak Tester Figure Comparalumen Light Levels TableLight leak test system Flash Simulator Board Figure10 Manual camera tester Manual Function Tester FigureManual Function Test Sequence Exit Pupil Test Optical System13 Aligning the exit pupil gage Entrance Pupil TestConcave Mirror Distortion Check USE of Analysis ChartsFresnel Quality Check Collimation16 Fresnel standards chart 18 Flex circuit terminal locations Camera/Shutter Isolation19 Test points on SX-70 shutters Camera Analysis ChartsPage Front COVER/SPREAD Roll Assembly InstallationRemoval Front cover hinge studs Repairs / Adjsutments Loose Front CoversBending the stop latch Interference Between Front and Bottom Covers Top Spread Roll LoosenessReplacing the Light Shield Cam Front cover light shield cam Mirror Cover / Boot AssemblyBoot retaining screws