Image Capture option limitation
The configuration for the image capture option affects memory capacity. If the configuration uses excessive memory, the warning message “Not enough memory…" will display. The total image capture frame rate must be no more than 120 fps due to memory size.
(Before event time + After event time) x (Image capture frame rate) must be under 120.
For example, if “Before event time" is 3 seconds, “After event time" is 2 seconds and “Image capture frame" is 3 fps, the total image capture frame rate is (3 + 2) x 3 = 15 fps.
If a warning message appears, reduce the value of the option.
Trigger Output
This is to configure digital output states and control script. The Pro Series Network Camera sends captured images via
Supply voltage to output port for xxx seconds.
This is to supply voltage to the output port when events are triggered. (This option is only activated when you select the "Activation of digital output" option in the "Trigger Condition" section.) During the activation period, which you can specify in seconds, the camera provides power to the GPIO connector in pins 3 and 4 – see Appendix F.
Send alarm to ETSP client:
By checking the box, an alarm will be sent to the ETSP client when the events are triggered. Refer to Section 9 for instructions on the ETSP client.
Send captured image to e-mail:
This is to designate a person to receive captured images via
Send captured image to FTP server:
This is to send captured video from the camera when an event is triggered. Enter an FTP server IP address, user ID and password, and select a directory to save video.
44