Polaroid 111523 manual Grid Adjustment, Grid Position

Page 31

Repair Manual

Macro 5 SLR Camera

 

 

Grid Adjustment

Note: Make sure the range lights are properly adjusted before adjusting the camera grid.

1.Take a picture of the test target.

2.Using a felt tip pen, draw diagonal lines from corner-to- corner on the picture of the test target (Figure 3-4).

CorrectIncorrect

Figure 3-4 Grid Position

Notes: • If the diagonal lines intersect in the center of the grid pattern, no adjustment is needed.

If the diagonal lines do not intersect in the center of the grid pattern, proceed to step 3 and adjust the position of the grid as needed.

3.Manually adjust the position of the grid as follows:

If applicable, remove the front cover as explained in section 5 of this service manual.

Turn the applicable adjustment screw (Figure 3-5) until the grid is properly centered.

4.Repeat steps 1 through 4 until the grid is properly centered.

31

Image 31
Contents Repair Manual Technical Services Burlington Road Bedford MA TEL FAXRev replaces September Contents Purpose of this Manual Organization of this Manual Other Documents Required for ServiceTheory of Operation AdjustmentsParts Replacement Camera DescriptionS1/S2 PC Board SchematicsCamera Description Important Safety Instructions Macro 5 SLR Camera GeneralCamera FeaturesMacro 5 SLR Features Dual-Light Rangefinder Macro 5 SLR Camera Features Cont’dTwo Built-In Electronic Flash UnitsRight/Left Hand Grips Battery CompartmentRed Shutter S1 Button Control Panel Control PanelReset Button Control Panel FeaturesPower Button Low BatteryRS232 Receptacle Control Panel Features Cont’dLighten/Darken Controls Magnification Status LightsDate/Time Display Specifications Accessories Specifications Cont’d MagnificationWeight DimensionsTheory of Operation Operation Camera SetupFilter Kit Macro 5 SLR Camera Camera Setup Picture Taking Macro 5 SLR Camera Picture Taking Adjustments Camera Test Fixture Ranging Aim Lights AdjustmentRange Light Adjustment Range Light Adjustments Grid Position Grid AdjustmentGrid Adjustments Troubleshooting Diagnostics Module Parts Replacement Macro 5 SLR Camera Required Tools and Equipment Disassembly/Assembly of Camera Inspection and CleaningElectrostatic Discharge Warning Removal -1, 5-2 and 5-2a Left/Right Cover Includes Front CoverCamera Disassembly Left/Right Bottom Screw Location Reassembly Removal Figure Front CoverReassembly Removal Figures 5-2 Rear CoverReassembly Bottom cover Bottom CoverReassembly Strobe PC Board Strobe PC BoardReassembly Trigger PC Boards Trigger PC Boards S1/S2 PC Board S1/S2 PC BoardReassembly Control Panel Reassembly Logic PC Board 10 Logic PC Board Camera Back 11 Camera Back Macro 5 SLR Camera Removal -12 and 5-12a Encoder Plate and PC Board12a Encoder PC Board Reassembly 13 Turret Assembly Turret AssemblyReassembly 14 Shutter Solenoid Assembly Shutter Solenoid AssemblyReassembly 15 Aim Light Cable Assembly Bulb Aim Light Bracket AssemblyReassembly 16 Date Code Module Date Code ModuleReassembly Firmware Logic PC Board 17 Firmware CPU Schematics S1/S2 PC Board Encoder PC Board Trigger PC Board Strobe PC Board 1 Strobe PC Board 2 Logic PC Board 1 Logic PC Board 2 Communication PC Board